Slinex VR-16 User manual

VR-16 Video door panel
User manual
{ Design. Uniqueness. Innovations}
SERIES
ACCESSORIES
Thank you for
choosing our equipment

12
Rev. 2.0
Safety instructions
Read and keep that manual.
The device installation process should be carried out by the qulied specialists.
Use the device from the –40 ˚C to +65 ˚C, always keep it within that
temperature range.
Installation surface should be free from vibration and impact inuence.
Keep this device far from open sources of heat, such as radiators, heaters, and
ovens.
The device can be installed near other electronic equipment in case if the
temperature of the environment does not exceed previously mentioned
range.
The device should be protected from the direct inuence of the natural
phenomena, such as direct sunlight, rain or snow.
Don’t use aggressive or abradant detergent for the device surface cleaning.
Use soft wet cloth or tissue to remove strong dirt.
Attention!
As a result of continuous upgrades and functionality
improvements, technical characteristics of the device can
be changed without any preliminary declaration.
This manual can contain some inaccuracy or misprint.
The owner reserves the right to make corrections to the information described
in the user manual and device package.
The last revision of this manual is available on www.slinex.com
Nature protection
Don’t throw away the device with other industrial or
nutritive trash if you see that symbol. Some regions have
separation and recycling systems for the electronic
equipment.
Connect with local authorities to receive information about recycling of
electronic equipment for your region.
Rights and limitation of liability
All rights reserved. Any part of that document can not be published in any
form, translated into other languages or reproduced in any way including
electronic or mechanical.
Document recording and copying is strictly denied without owner permission.
!
{ Design. Uniqueness. Innovations } SERIES
ACCESSORIES

34
Sensor type
Sensor resolution
View angle
Backlight
Voltage
Lock relay continuous current
Power consumption
Installation type
Door panel dimensions
Installation box dimensions
Working temperature
1/3”, CMOS
800 ТV-lines
80˚
Infrared LED’s. 1,5 m distance
+12...15 V from the door monitor
10A
Up to 3 W
Flush mount
180×101×28 mm
165×85×35 mm
–40 ... +65 ˚C
Table of contents
1. Package .................................................................................................................................. 4
2. Specication ......................................................................................................................... 4
3. Description............................................................................................................................ 6
4. Schematic diagram ............................................................................................................ 7
5. Installation............................................................................................................................. 8
6. Limited Warranty................................................................................................................. 9
1. Package
VR-16 video door panel − 1 pc.
Door phone connector − 1 pc.
Lock connector − 1 pc.
Flush mounting box − 1 pc.
Angle bracket − 1 pc.
Mounting screw and hex key − 1 pkg.
User manual − 1 pc.
2. Specication
{ Design. Uniqueness. Innovations } SERIES
ACCESSORIES

56
1
2
3
4
5
6
Video camera
Night infrared backlight
Speaker
Call button
Microphone
Light sensor
5
1
2
3
4
6
3. Description
VR-16 pinout
180 mm
101 mm 28 mm
Note:
«Lock 1» and «Lock 2» are normaly opened built-in relay contacts for the
elctromechanic lock connection. Maximum relay current is 10 А.
Lock connection schematics can be found on the 7th page of that manual.
VR-16
Lock 1 Lock 2
Video Ground Audio Power
LockMonitor
{ Design. Uniqueness. Innovations } SERIES
ACCESSORIES

78
VR-16 door panel ush mount:
1) Prepare the hollow inside the wall according to the sizes mentioned on the
4th page of the manual, 150-160 cm from the oor line.
2) Mount ush mounting box into the hollow and x it.
3) Connect all communication wires and x the door panel inside ush
mounting box by the hex screw from the down side.
Video
Ground
Audio
Power
VR-16
Video Ground Audio Power Lock 1 Lock 2
Lock
Lock power
supply
4. Schematic diagram 5. Installation
SL-07M (Master)
Door 1
Door 2
CCTV 1
CCTV 2
Input
Output
PowerTV out
{ Design. Uniqueness. Innovations } SERIES
ACCESSORIES

910
6. Limited warranty
Manufacturer guarantees product normal functioning during the warranty
period if the user keeps all safety instructions described in that manual.
Warranty period is 12 months from the moment of the product purchasing.
Warranty period allows user to make guarantee repair in cases when normal
functioning of the product was violated by the fault of manufacturer and the
user haven’t oend transporting, installation and working conditions.
This limited warranty does not cover any damage to the product that results
from improper installation, accident, abuse, misuse, natural disaster,
insucient or excessive electrical supply, abnormal mechanical or
environmental conditions, or any unauthorized disassembly, repair or
modication.
Warranty void in such cases:
• the product was damaged by the fault of the customer;
• the product wasn’t properly installed according reccomendations from
the manual;
• the sticker on the backside of the product was broken;
• the product was not used for its intended function.
This limited warranty covers only repair, replacement, refund or credit for
defective products, as provided above. Manufacturer is not liable for, and does
not cover under warranty, any damages or losses of any kind whatsoever
resulting from loss of, damage to, or corruption of, content or data or any costs
associated with determining the source of system problems or removing,
servicing or installing products. This warranty excludes third party software,
connected equipment or stored data. Manufacturer is therefore not liable for
any losses or damage attributable to third party software, connected
equipment or stored data.
In the event a product has been discontinued, manufacturer shall either repair
the product, oer to replace it with a comparable product or provide a refund
at the lesser of the purchase price or the product’s current value.
Repaired or replacement products will continue to be covered by this limited
warranty for the remainder of the original warranty term.
{ Design. Uniqueness. Innovations } SERIES
ACCESSORIES