SmartBidet SB-2600 User manual

SB-2600
Quick Installation Guide
20.4”
6.4”
11.4”
8.1”
14.5”
14.9”
Remove your existing toilet seat, lid, and accessories and store them away.
The toilet dimensions must be within those shown
below. Do not install this unit on a toilet that does
not meet these dimensional requirements.
Place the base plate and bolt cases over each
toilet mounting hole. Insert the mounting bolts
through the base plate and toilet mounting holes.
Screw in the nuts onto the mounting bolts.
This model fits both elongated and round toilets.
There may be a slight overhang for certain
round toilets.
1
2
3 4
Bidet DimensionsToilet size (Elongated)
How to mount the base plate How to attach and detach the unit
1.
Base plate
Bolt case Nut
Mounting bolt
Slide the unit until it
clicks into the base plate.
Lift the unit up
and forward.

5Connections
6
2.
Close the bathroom water supply valve by turning it clockwise.
Flush the water tank completely to empty.
Remove the existing water supply hose from the tank.
Install the 1/2” C T-valve on top of the water supply valve.
Use the 3/8” spare nut & washer if your water supply valve’s
diameter is 3/8”.
Connect one of the flexible hoses from the T-valve to the water tank.
Connect another flexible hose from the T-valve to the main unit.
Open the water supply valve by turning it counter clockwise.
Check for any water leaking or dripping.
smartbidet.net
Supplier: Hitrons Solutions Inc.
Address: 88 Portland Avenue Suite M
Bergenfield, NJ 07621
Limited 1 year warranty
For Customer Service Inquiries,
please visit www.smartbidet.net
email us at [e-mail],
or call us at 1-800-515-3430
(Mondays to Fridays 9:00am to 5:00pm EST)