SMC Networks TigerStore SMCNAS04 User manual

Backup Utility
USER GUIDE

NAS Backup Master
User Guide
May 2007

TRADEMARKS
All brand and product names are trademarks or registered trademarks of their
respective companies.
NOTE
The information in this manual is subject to change without notice.

Table of Contents
Table of Contents................................................................................. v
Chapter 1 Setting Up the Backup Master .................................... 7
1.1 Installing the Backup Master................................................................7
1.2 Configuring the Backup Master .........................................................22
Backup Now.................................................................................26
Basic Setup..................................................................................29
Schedule Setup............................................................................32
Advanced Setup...........................................................................35
Restore.........................................................................................41
Special notice information............................................................51

7
Chapter 1 Setting Up the Backup
Master
1.1 Installing the Backup Master
IMPORTANT: Do not turn on power to your storage system and do not connect to your
computer until after you have finished installing the Backup Master.
You need to install the Backup Master before you can perform any system
configurations.
1. Make sure that your computer is turned on.
2. Insert the included Utility disc into your optical drive and the following
screen appears.
Click “Install NAS Backup Master.”
3. When the next screen appears, select the desired language (English/
Traditional Chinese/Simplified Chinese).

8
4. Click “Next” and the following screen appears.

9
5. Click “Next” to continue and the following screen appears. If you want to
select a different folder, click “Browse” and select your desired folder.

10
6. To continue, click “Next” and the following screen appear. If you want to
select a different Start menu folder, click “Browse” instead and select your
desired folder.

11
7. To continue, click “Next” and the following screen appear. Click “Create a
desktop icon” if wish to do so.

12
8. Click “Next” to continue and the “Ready to Install” screen appears.

13
9. Click “Install” to continue and the following screen appear, showing the
progress of installation.

14
10. When the next screen appears, click “Finish” to exit the Backup Master
installation.
The “NAS Backup Master Detector” icon would appear on your Windows
system tray to signify that the Backup Master was successfully installed.

15
11. Install the Backup program user manual

16
12. Click “Next” to continue and select destination location
13. Click “Next” to continue and select start menu folder

17

18
14. Click “Next” to continue and ready to Install

19
15. Click “install” to continue and installing

20
16. finish install

21
17. Press the Power button to turn on your storage system.
18. Connect one end of the Ethernet cable to the network connector on the back
of your storage system and the other end to your computer.

22
1.2 Configuring the Backup Master
After installing the Backup Master, you can start the configuration process.
Your choice is important and impacts how best you can use the device. To start
using the Backup Master:
zDouble-click the “NAS Backup Master Detector” icon on your Windows
system tray, or
zSelect Start ÆProgram ÆNAS Backup Master ÆNAS Backup Master.
NOTE: The first time you start up the Backup Master, the following screen appears. You
need to enter the Product Serial Number found on the cover of your Utility disc.
Note : Please pay attention the number of people use the software at the same
time and the number of install the software of your Serial Number, if exceed,
there are follow error Information will out :
1. If exceed the number of install the software, alarm will out as follow picture