Smeg WD6010 User manual

19510091207
Smeg S.p.A. - Instruments Division - [email protected]
WD6010 –GW6010
WD7010 –GW7010
WD7015 –GW7015
PACKAGE REMOVAL, PREPARATION FOR MOVEMENT (REFER TO THE INSTRUCTION MANUAL FOR COMPLETENESS)
Models
WD6010, GW6010,
WD7010, GW7010
WD7015,
GW7015
Max machine net weight (without packaging material)
300 kg
400 kg
Max gross weight
340 kg
450 kg
Storage Temperature range
5°C –40°C
The base of the appliance is secured to a pallet, which is used for lifting and transporting it. When moving the
appliance around, a forklift truck must be used. Images used: illustrative purposes only.
PACKAGE REMOVAL AND PREPARATION FOR MOVEMENT
Procedure to follow to remove the package, referring to the following images:
A.1 –Remove the package.
A.2 –Check that all lower panels are not installed.
A.3 –Open the lower metallic panels (both the loading side and the unloading side) to have access to the fixing
screws. The fixing screws to the pallet, both on the loading side ("unclean side") that on the unloading side ("clean
side"), must be unscrewed in order to remove the machine from the pallet.
A.4 - Lateral machine unload: insert the forks of the forklift truck from the side, paying attention to remain under the
lateral plate (forks width about 430mm). place the machine on the floor;
A.5 - The machine is now standing on the wheels and can be positioned (short paths).
A.6 - Once the machine has been placed, screw or unscrew the feet in order to adjust its position and level it.
A.1
A.2
A.3
A.4
x 2

19510091207
Smeg S.p.A. - Instruments Division - [email protected]
A.5
A.6
Note: in some case there is a rubber tube used to prevent the pin from being unscrewed: this must be eliminated to allow height
adjustment.
WD7010 –GW7010, WD7015 –GW7015: loading side –to access the screw, you need to open the detergent compartment and
remove the lower stainless steel panel.
Procedure to follow to get the machine off the pallet –using the tail lift:
B.1 - Remove the front wooden Stop.
B.2 –Approach with the tail lift to the pallet and frontally to the machine, make the machine slide on the platform, then, carefully,
place the machine on the floor.
Follow the above instructions to position and level the machine.
B.1
B.2
Smeg S.p.A.
Instruments Division
Via Leonardo da Vinci, 4 –42016 Guastalla (RE) Italy
Tel. [phone] –Fax [phone]
E-Mail: [email protected] - [email protected] - [email protected]
www.smeg-instruments.com