Solar Goes Green SGG-F108-2 User manual

SolarGoesGreen SGG-F108-2 Owner's Manual
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
1. Description
The SolarGoesGreen solar LED Flood Light is a premier choice for indoor or outdoor lighting.
Widely used for gardens, parks, warehouses, garages, driveways, signs, yards, farms,
horse riding arenas and businesses. The SolarGoesGreen flood light is easly installed.
The battery is protected by an auto-detection circuit in the system to control the brightness
of the lamp, allowing the lamp to operate longer as the battery charge declines.
2. Parts
① Solar Panel
② LED Lamp and Battery
③ Ground Stake for Solar Panel
3. Installation
Please check the below items before installation:
1) Connect the solar panel wire to the LED lamp;
2) Mount the solar panel facing sunlight using the ground mount stake and then switch the
power ON (Fig 1); The lamp will light up and then shut down automatically after 15 seconds;
3) Completly shield the face of the solar panel by laying it face down on a flat surface or cover
the panel with a thick, black cloth. The LED lamp will turn on after 15 seconds.
After checking the items above, turn off the power and install the lamp in the desired
position; place the solar panel with a ground stake where the solar cell will absorb
maximum sunlight. The solar panel receives maximum sunlight only when the
panel is perpendicular to the sunlight.
①
②
③

4. Operation
The lamp will light up automatically after dark. The brightness is at maximum when the
battery is fully charged; and in a semi-bright state when the battery is only partially
charged, allowing it to save power and extend the lighting time.
Switch Description:
z OFF ---- complete OFF, not charging
z ON ---- both lighting and charging
5. Notes )LJ,3RZHU2Q
1. Constantly charged the battery for at least 15 hours before first using.
2. The solar panel can not be placed in the shade; it must be placed where it can receive max sunlight.
6. Battery Maintenance & Replacement
1) Maintenance
When the light isn’t used for lighting, please switch ON, and charge it 20 hours or
more under the sunlight, then switch OFF.
Please note the battery must recharge periodically even if not in use for 3 to 5 months,
or the battery will be damaged!
2) Replacement
If the lamp begins to illuminate dimly or last shorter time, you should replace the
rechargeable lead acid battery in the following way:
1）Remove the face of the lamp by removing the screws.
2）Unscrew 4 battery screws and remove the cover on the battery..
3）Pull out two the terminals from the battery and take out the old battery.
4）Replace with a new battery and remount in reverse steps as done above.
Warning:
1) Do it carefully to prevent wires from being damaged.
2) Be sure that battery polarities are correct. Wrong polarity is dangerous.
3) Do not dispose of the old battery. It should be recycled.
www.SolarGoesGreen.com