SolrenView PVI 23TL User manual

SolrenView Installation Guide PVI 14-36TL Series
DOCR-070580-A Page 1of 5
SolrenView Installation Guide
for PVI 14-36TL Inverters
Revision A
©2015, Solectria –A Yaskawa Company

SolrenView Installation Guide PVI 14-36TL Series
DOCR-070580-A Page 2of 5
This installation guide provides instructions on installing the SolrenView monitoring DAS into
the inverter.
Required tools:
3mm Allen wrench (non-powered)
#2 Phillips screwdriver
REMOVING THE WIRING BOX COVER
PVI 23/28/36TL Inverters
1. Disconnect AC/DC disconnects.
2. Wait 5 minutes for capacitors to discharge.
3. Note that all fuses are still live.
4. Use standard electrical safety practices while performing the job.
Use a 3mm Allen bit to loosen the
wiring box cover. Do NOT use an
electric screw driver. Remove the
cover.
PVI 23/28/36TL

SolrenView Installation Guide PVI 14-36TL Series
DOCR-070580-A Page 3of 5
REMOVING THE WIRING BOX COVER
PVI 14/20TL Inverters
1. Disconnect AC/DC disconnects.
2. Wait 5 minutes for capacitors to discharge.
3. Note that all fuses are still live.
4. Use standard electrical safety practices while performing the job.
Using #2 Phillips screwdriver,
remove the 6 screws holding the
cover to the chassis. Retain
hardware for later use.
PVI 14/20TL

SolrenView Installation Guide PVI 14-36TL Series
DOCR-070580-A Page 4of 5
SOLRENVIEW INSTALLATION INSTRUCTIONS
PVI 23/28/36TL
1
2
3
4
5
Pre-bend the wire harness as shown.
Place the data logger in its location.
Insert the provided hardware in the
4 locations shown. Correct
sequence: screw, lock washer, flat
washer. Torque to 8 in-lbs.
Add Ethernet connection
prior to mounting DAS.
Connect the 5 pin green connector.
Replace the cover and torque to 16 in-lbs.

SolrenView Installation Guide PVI 14-36TL Series
DOCR-070580-A Page 5of 5
SOLRENVIEW INSTALLATION INSTRUCTIONS
PVI 14/20TL
4
3
2
1
Loosen and discard right standoff.
Insert the provided hardware in the 3
locations shown. Correct sequence:
screw, lock washer, flat washer.
Torque to 8 in-lbs.
Connect the 5 pin green connector.
Add Ethernet connection.
Replace the cover and torque to 10 in-lbs.