Soltech NUVO User manual

SPECIFICATIONS
0225W / 2,500LM
2,000mAh / 3.7V
2835 50PCS
1.0 W, Mono-crystalline Silicon
18 hrs
>10 Days
3 Different Modes
120° / 19.7ft
32°F–113°F
IP65
3 YEARS
35,000 hrs
≤8.2 ft
Solar Light X 1, Screw Bag X 1,
User Manual X 1
POWER / LUMEN
LED
LI-ION BATTERY
SOLAR PANEL
CHARGING TIME
RUN TIME@FULL POWER
WORKING MODE
DETECTION ANGLE / AREA
CHARGING TEMP
IP DEGREE
WARRANTY
LIFESPAN
INSTALLATION HEIGHT
PACKING
011
INTRODUCTION
1. Do not install the lamp away from the sun, under a shade, or between
high buildings that will cover the lamp. It will affect sunlight absorption
and shorten the lamp’s autonomy.
2. Do not use the lamp in areas with temperatures above 113°F or below
32°F or it will cause a rapid attenuation of the battery affecting battery
life and damage to the battery.
3. Do not use non-standard installation accessories to install the lamp,
otherwise installer will be responsible for any accident or damage.
4.Choose appropriate operating mode based on your local sunshine.
Warning
1. Keep device away from fire and oil to avoid any fire or explosion.
2. Only professional technicians should attempt to disassemble the lamp
in order to avoid any damage to the lamp.
3. It is not advised to disassemble the battery for personal use.
4.If the lamp does not receive charge for 3 days, the battery might run
out of battery. You will need to charge it underneath bright sunlight.
5. In order for the lamp to work in an ideal state for a long time, please clean
the solar panel according to local dust conditions at least once a year.
Copyright©2021–2022 SOLTECH LLC, All Rights Reserved.
SOLTECH LLC reserves the right to update all product data sheets at any time. Consult
SOLTECH marketing specialists for publication updates at www.soltechlighting.com
SOLTECH offers
advanced LED
technology that
is eco-friendly
and utilizes
clean energy.
NUVO
1460 Park Avenue.
Emeryville CA 94608 USA
www.soltechlighting.com
Please read and follow all instructions to operate. Save this
manual for future reference.
SOLAR LED
WALL LIGHT
25W 2,500LM 4,000K

INSTALLATION
03
04
OPERATING
MODES
PRESS BUTTON TO SELECT WORKING MODE
Long Press 1.5s for TURN ON / OFF
MODES SWITCH
Short press it to change lighting mode
MODE SWITCH WITH RED LED INDICATOR
MODE A: Flashing 1 time, 50Lm + PIR 2,500Lm 10s
MODE B: Flashing 2 times, 0Lm + PIR 2,500Lm 10s
MODE C: Flashing 3 times, 50Lm to dawn
MODE A:
Automatically turns on to weak brightness (50Lm).
When motion is detected in the range 19.7 ft, fixture
turns to full brightness (2,500Lm) for 10 seconds.
MODE B:
Automatically turns off. When motion is
detected in the range 19.7 ft, fixture turns to full
brightness (2,500Lm) for 10 seconds.
MODE C:
Automatically turns on to weak brightness (50Lm)
until dawn.
1. Measure the hole drillings then drill 2 holes
2. Fix the expansion plugs into the holes
3. Fix the lamp on the wall and secure with
the screws
Face the solar panel toward the sun to
effectively charge the built-in Li-ion battery.
120° 120°
120°
120° 120°