Furniture of America CM3751PC-2PK User manual

Assembly Instructions
EASY
ToolsRequiredFor Assembly:
CM3751PC-2PK
Page 1 of 5 Rev:15-01- 30

Page 2 of 5

Backrest W/Legs
Seat
Allen Allen M5
Before you begin, please read Page 2
of "Assembly and CareAdvice".
And remember, do not tighten until
each step is completed orinstructed.
Bolt(5/16"x3-1/4"L)
Bolt(5/16"x2-1/4"L)
Bolt(5/16"x1-1/2"L)
Page 3 of 5

Page 4 of 5
I. Place the backrest with legs (#1) on a
protected surface. Align the seat (#2)
with the pre-drilled holes of the backrest
with legs (#1).
II. Prepare a bolt assembly by inserting
FIRST the lock washer (#E) onto the
bolt (#C) and then the flat washer (#D)
onto the SAME bolt (#C), in that order.
III. Insert the bolt assembly through one
of the pre-drilled holes in the center of
the seat (#2) and secure the bolt using
the Allen wrench (#F) to lock it with the
backrest with legs (#1). Repeat the
process with second bolt.
I. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#E) onto the bolt
(#A) and then the flat washer
(#D) onto the SAME bolt (#A),
in that order.
II. Insert the bolt assemblies
through the pre-drilled holes
in the corners of the seat (#2)
and secure those bolts using
the Allen wrench (#F) to lock
them onto the backrest with
legs (#1).

Turn right(clockwise)totighten
Turnright(clockwise)totighten
#G
Page 5 of 5
ASSEMBLY IS COMPLETED
I. Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#E) onto the bolt (#B) and then
the flat washer (#D) onto the
SAME bolt (#B), in that order.
II. Insert the bolt assemblies
through the pre-drilled holes in
the corners of the seat (#2) and
secure those bolts using the
Allen wrench (#F) to lock them
with the front leg (#3).
I. Align the front support (#4) and the side supports (#5) with the pre-drilled holes on the legs.
II. Insert the screw (#G) at a diagonal using a Phillips screwdriver. Repeat for the remaining screws (#G).
Tighten screws until properly secure.