1Lens mount (C mount)
A commercial C mount lens as well as
Sony standard lenses can be used.
2Camera fixing reference hole
High-precision screw hole machined
on the lens mount surface.
3Screw hole for tripod adaptor
installation (VCT-ST70I)
412 pin multi-connector
The 12 pin multi-connector is
connected to a DC IN/SYNC
(DC power/sync signal input)
5BNC connector
Video out
6Gamma correction
ON/OFF switchable
7Internal/External
synchronization switch
In the EXT position, if there is no
external sync input, the internal sync is
activated inside the camera.
In this case, HD/VD signal is not output
through the 12 pin multi-connector.
8Trigger polarity switch
The trigger polarity is selectable
(neg/pos polarity)
975 Ωtermination switch
0Dip switch
Dip switch 1 - 4: Shutter speed
Dip switch 5: FRAME/FIELD exposure
Dip switch 6 - 8: Normal shutter mode,
External trigger shutter
mode, restart/reset mode
AGain switch
A: Image output at a fixed level of
image according to the brightness
of the subject. (Variable range: 0 to
18 dB)
F: Fixed gain 0 dB
M: gain (manual)
Factory setting: the variable gain is adjusted to
the fixed sensitivity for a
standard subject. When using
two or more XC-ST50/50CE,
XC-ST30/30CE cameras,
identical images of the same
subject can be attained.
BGain control
The gain can be adjusted between 0 to
18 dB when the gain switch is set to "M".
Pin No. External HD/VD sync Internal HD/VD sync External VS sync
1 GND GND GND
2 +12 V +12 V +12 V
3 GND GND GND
4 VIDEO output VIDEO output VIDEO output
5 GND GND GND
6
External HD input Internal HD output
-
7
*3 External VD input Internal VD output
VS
8 GND GND GND
9
---
10 *4 WEN output *2 WEN output *2 WEN output
11 TRIG input TRIG input TRIG input
12 GND GND GND
*3 : In restart/reset mode VD input is necessary
*4 : WEN output is only effective in EXT trigger shutter mode
No. Switch Factory setting
6Gamma correction ON/OFF OFF
7Internal/External sync EXT
8Trigger polarity +
975 Ωtermination ON
0Dip switch
1·2·3·4:Shutter speed OFF
5: Field/Frame OFF
6·7·8:
normal shutter/EXT trigger shutter/restart reset
OFF
AGAIN FIX
● Rear Panel Factory settings
● Side
● 12 pin multi-connector
● Rear Panel