Tactile dot
English
Stereo headphones
How to use (see fig. )
These headphones are for use with a stereo mini jack.
Extend the slider to adjust the length.
Wear the headphone marked
on your right ear, and the one marked
on your left ear.
There is a tactile dot on the unit marked to distinguish the left side.
How to confirm the model name (see fig. )
The location of the model name, (“MDR-ZX300” or “MDR-ZX100”) is shown in the
illustration. If you have a question about the product, check the model name beforehand
to let us know your model.
Note
When checking the model name, do not move the headphone beyond its normal range.
Precautions
Listening with headphones at high volume may affect your hearing. For traffic safety,
do not use while driving or cycling.
Do not subject the headphones to excessive shock.
Handle the driver units carefully.
Do not put weight or pressure on the headphones as it may cause the headphones to
deform during long storage.
The earpads may deteriorate due to long-term storage or use.
Do not leave the jack plug dirty otherwise the sound may be distorted.
Clean the headphones with a soft dry cloth. Do not blow on the units when cleaning.
Do not allow the plug to become dirty, otherwise the sound may deteriorate.
Do not leave the stereo headphones in a location subject to direct sunlight, heat or
moisture.
Optional replacement earpads can be ordered from your nearest Sony dealer.
MDR-ZX300
Features
Neodymium magnet delivers powerful sound.
Slim, folding design for easy portability.
Resists high power input up to 1,000 mW.
Specifications
Type : Closed, dynamic (supra-aural) / Driver unit : 30 mm, dome type (CCAW Voice
Coil) / Power handling capacity : 1,000 mW (IEC*) / Impedance : 24 Ω at 1 kHz /
Sensitivity : 102 dB/mW / Frequency response : 10 – 24,000 Hz / Cord : 1.2 m (47 1/4 in),
Y type / Plug : Gold-plated L-shaped stereo mini plug / Mass : Approx. 120 g (4.23 oz)
without cord / Supplied accessory : Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
MDR-ZX100
Features
30 mm driver unit for clear sound.
Slim, folding design for easy portability.
Resists high power input up to 1,000 mW.
Specifications
Type : Closed, dynamic (supra-aural) / Driver unit : 30 mm, dome type (CCAW Voice
Coil) / Power handling capacity : 1,000 mW (IEC*) / Impedance : 24 Ω at 1 kHz /
Sensitivity : 100 dB/mW / Frequency response : 12 – 22,000 Hz / Cord : 1.2 m (47 1/4 in),
Y type / Plug : Gold-plated L-shaped stereo mini plug / Mass : Approx. 120 g (4.23 oz)
without cord / Supplied accessory : Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
This mark is valid only in those European countries where it is legally
applicable.
