MODEL
Specifications
*1ANSI lumens is a measuring method of the American National Standards Institute IT7.228.
*2Excluding protruding parts.
*3Laser Type: Class II Wavelength: 645 nm Output: 1mW
OPTICAL
VPL-PX15 VPL-PX11
Projection system
LCD panel
Projection lens
Lamp
Screen coverage
Light output
Color system
Resolution
Acceptable signals
Computer
Scanning frequency (horizontal)
(vertical)
Video
Cabinet color
Speaker
Power requirements
Power consumption
Operating temperature
Operating humidity
Dimensions
Weight
Heat dissipation
VIDEO IN Composite
Y/C IN
Y
C
AUDIO IN
INPUT A Analog RGB/Component
R/R-Y
G
G with Sync/Y
B/B-Y
SYNC/HD
Composite sync
Horizontal sync
VD
Vertical sync
AUDIO IN
INPUT B Analog RGB
R
G
G with Sync
B
SYNC/HD
Composite sync
Horizontal sync
VD
Vertical sync
AUDIO IN
ETHER
PC Card slot
USB
OUTPUT Analog RGB/Component
R/R-Y,G/Y,B/B-Y
SYNC/HD,VD
AUDIO(variable out)
REMOTE:RS-232C
3 LCD panels, 1 lens projection system
0.9-inch p-Si TFT LCD panel with Micro Lens Array
2,359,296 pixels (786,432 pixels x 3)
1.3 times manual zoom lens , F1.7 to 2.1, f33.6 to 42 mm
200 W lamp
40 to 300 inches (viewable area, measured diagonally)
2000 ANSI lumens*1
NTSC, PAL, SECAM, NTSC4.43, PAL-M, PAL-N
VIDEO: 750 TV lines,
RGB: 1024 x 768 pixels
19-92Hz
48-92Hz (up to 85Hz for SXGA 1280x1024 signals)
15kHz RGB/component 50/60Hz,composite video ,Y/C video
Silky Silver
AC 100 to 240 V, 50/60 Hz
32 to 95 ˚F (0 to 35 ˚C)
35 to 85%
12 7/8 x 4 3/8 x 11 1/4 inches (325 (W) x 110 (H) x 285 (D) mm)*2
Phono type, 1.0 Vp-p ±2 dB, sync negative, 75 Ω
Mini DIN 4-pin
1.0 Vp-p ±2 dB, sync negative, 75 Ω
Burst 0.286 Vp-p ±2 dB (NTSC), 75 Ωor 0.3 Vp-p ±2 dB (PAL), 75 Ω
Stereo mini jack, 500 mV rms, impedance more than 47 kΩ
HD D-sub 15-pin (female)
0.7 Vp-p ±2 dB, positive, 75 Ω
0.7 Vp-p ±2 dB, positive, 75 Ω
1.0 Vp-p ±2 dB, sync negative, 75 Ω
0.7 Vp-p ±2 dB, positive, 75 Ω
1.0 to 5.0 Vp-p, high impedance positive/negative
1.0 to 5.0 Vp-p, high impedance positive/negative
1.0 to 5.0 Vp-p, high impedance positive/negative
Stereo mini jack, 500 mV rms, impedance more than 47 kΩ
HD D-sub 15-pin (female)
Gain unity, 75 Ω
4.0 Vp-p(open),1.0 Vp-p, 75 Ω
Stereo mini jack,max 1 Vrms, When an output signal is 500 mVrms, impedance less than 5 khms
UL, cUL, DHHS, DNHW,DENAN, FCC class A, NEMKO, CE (LVD, EMC), C-Tick, VCCI, JEITA
Max. 2 W x 2 (stereo)
Max. 290 W, Standby 4.2 W
Approx. 10 lb 13 oz (4.9 kg)
989.6 BTU
HD D-sub 15-pin (female)
0.7 Vp-p ±2 dB, positive, 75 Ω
0.7 Vp-p ±2 dB, positive, 75 Ω
1.0 Vp-p ±2 dB, sync negative, 75 Ω
0.7 Vp-p ±2 dB, positive, 75 Ω
1.0 to 5.0 Vp-p, high impedance positive/negative
1.0 to 5.0 Vp-p, high impedance positive/negative
1.0 to 5.0 Vp-p, high impedance positive/negative
Stereo mini jack, 500 mV rms, impedance more than 47 kΩ
UP (B type female) x 1(INPUT A)
D-sub 9-pin (female)
GENERAL
INPUTS/
OUTPUTS
SAFETY REGULATIONS
SUPPLIED ACCESSORIES
SIGNALS
Max. 0.5 W x 2 (stereo)
Max. 300 W, Standby 4.2 W
Approx. 11 lb 11 oz (5.3 kg)
1023.9 BTU
10BASE-T/100BASE-TX
PC Card slot Type II
UP (B type female) x 1, Down( A type female) x 1
Remote Commander (VPL-PX15*3and VPL-PX11 have their dedicated remote control units respectively.)
Signal Cable SMF-410: HD D-sub 15-pin to D-sub 15-pin, USB Cable: A type to B type,
USB Application Software Projector Station (CD ROM), AA size Battery (2)
Air Filter (for replacement), AC Power Cord, Operation Manual, Operation Manual for Networking (VPL-PX15 only), Installation
Manual for Dealers, Specified/recommended PC Card/Wireless LAN Access Point List (VPL-PX15 only),
Quick Guide