VGC-RA7xx Series Hard Disk Drive
Replacement Instructions
P/N 994629300 Rev. C 2/2
Ensure that all 4 holes (2 on
each side) are in alignment
Step 4. Proceed to disconnect the IDE cable [1] and power
cable [2] from the hard drive. IMPORTANT! Some force may
be required to initiate the removal of the cables. Take caution
not to damage the cables. Pull with equal force on both sides of
each cable to remove them as shown above.
Step 5.Release the HDD bracket enclosure by pulling the
black handle as shown. Some force may be required to
unlock the handle. Slide the complete HDD bracket
enclosure out of the unit.
Step 6. Using the enclosed magnetic screwdriver, remove
the four (4) screws that secure the hard drive into the bracket
enclosure. IMPORTANT! Before proceeding, take note of
original position of the drive inside the bracket. Slide out the
original drive.
Step 7. Slide new hard drive inside the bracket
enclosure with all holes in alignment. Reinstall the four
(4) screws previously removed, securing new drive into
the bracket.
Step 8. [A] Reinstall the HDD bracket enclosure being
careful to align the guides. Some force may be required to
slide the HDD bracket enclosure into the unit. [B] Lock the
black handle in place.
Step 9. Reconnect the IDE cable [1] and power cable
[2] to the hard drive. Reinstall side panel removed in step
2. Connect your PC and continue with the recovery
instructions. Return the old hard drive to Sony following
the included shippinginstructions.
[A]
[1]
[2]
CAUTION!
Sharp Edge
Notice the original position of the
handle and HDD Notice position of the handle
and pin’s orientation
[B]
CAUTION!
Sharp Edge [1]
[2]
