Sorceressita Food Ingredient Cleaner Technical manual

Food Ingredient Cleaner
Operation Instruction
EPA Reg. No. 100962
EPA Est. No. 100957-CHN-1
A: Product Appearance
I. Main body
II. Charging Cradle

B: Product Components
1.1 Top cap 1.2 Cathode electrode plate 1.3 Screws 1.4 Insulating pad 1.5 Anode electrode plate
1.6 Waterproof working body (middle base) 1.7 PCB module and battery 1.8 Charging column of body
1.9 Bottom cap of main body 2.0 Charging cradle 2.1 Charging connectors
C: Product Features
I. Functionality
Built on MNB (Micro-nano bubbles) and HPF (Hydroxyl Purification Factor) technologies, it can eliminate harmful substances (bacteria,
pesticides, hormones and etc.) existing on your food ingredients (fruit, vegetables, seafood, meat).
II. Multi-protect Safety Design
No AC power connected in working mode. Low voltage (24V) output with IPX7 waterproof level. Food grade ABS shell material.
III. Simplicity
Keyless design. Automatic operation without any button.
IV. Portability
With High-capacity battery, it can be taken outdoor for picnic or camping.
D: Operation Method
I. Cleaning Operation
1. Please fully charge (maximum 1.5 hours) before first usage. The charging process is done when the indicator remains blue. See “II.
Charging Operation” for more information.
2. Rinse the ingredients by tap water to remove the visible impurities.
3. Put the main body into a container with water, and it starts to work automatically with its indicator flashing blue slowly. “Fog” (micro-nano
bubbles) is generated for cleaning. Now put ingredients in.
4. It stops working automatically after 6 minutes (a working cycle). Take out the ingredients and rinse them with tap water again. Then it’s
done!
II. Charging Instructions
1. Please keep the surface of charging cradle and main body dry before charging.
2. Connect the charging cradle to AC power, and put the main body on the cradle. Make sure the charging columns (1.8) and the charging
connectors (2.0) are well contacted.
The indicator flashes in red slowly when charging, and remains blue when charging completed.
III. Tips
1. If you wish to suspend, take the machine out from water and it will stop working immediately.
2. You can use any type of container for cleaning. 3L-6L volume is suggested. If the water volume is more than 6L, it would be better with

two working cycles.
3. The cleaning could achieve the best effect if the ingredients are completely immersed into water. If not, please manually press or roll the
object to fully contact the water.
4. Red indicator means it needs charging. A fully charged battery can support up to 5 working cycles.
E: Maintenance Notes
I. Cleaning of electrode plate
After the machine has been used for a long time, scale may adhere to the surface of cathode electrode plate (1.2); the cleaning steps are
as follows:
1. Put a soft cloth on the flat table, pick up the main body (1), hold the top cap (1.1) with your hand and rotate it inward, then remove the
top cap (1.1).
2. Remove the screw (1.3) using a screwdriver and take out the cathode electrode plate (1.2).
3. Put the cathode electrode plate (1.2) into a heatable container, add an appropriate volume of water, and keep the water level above the
surface of cathode electrode plate (1.2). Pour 1 bag of high-efficiency descaling agent/vinegar into water, boil for 3 minutes, then rinse it
with tap water. At last, wipe the surface of the cathode electrode plate (1.2) with a brush/towel.
4. Cover the screw with the boss of silicone insulating plate (1.4), keep the surface flat, align the cathode electrode plate (1.2) at the
mounting position and cover it on the silicone insulating plate, then tighten the screw (1.3); finally, align the unlocking position at the top
cap of main body (1.1) with the charging columns of body (1.8), and cover it at the position about 1cm from the inside, rotate it outwards,
then fasten it to complete the installation.
II. Cleaning of charging columns
When you see water scale adhered to the charging columns (1.8), you can clean them with a wirecloth.
III. Cleaning of appearance
The main body (I) can be cleaned with neutral disinfectant if it is dirty.
F: Fault Examination and Analysis
Status
Cause Analysis
Inspection and Repair
Not charged
1. Charging cradle is not aligned with the main
body accurately
2. Poor contact between the charging connector
and the socket
1. Move it a little bit left and right to ensure accurate
alignment
2. Check the availability of the socket, or change a
new one
When cleaning meat,
unable to work after a
short time
The hormones, antibiotics and dirt cleaned from
the meat stick to the electrode plate, thus resulting
in short circuit
1. Rinse the machine with tap water
2. For cleaning meat, put the meat into water after the
machine starts to work
Not fully charged
Water scale exists on the charging column, thus
causing poor contact
Perform maintenance in accordance with
“Maintenance Note II”
Still work after leaving
water
Water inside the machine is not eliminated
completely
Shake to eliminate water inside

G: Precautions for Use
Prohibited
Do not charge when the main body or charging cradle is wet
Do not use in hot water
Do not place the product near any heat source or open flame
Precautions
Keep the charging cradle dry and free of moisture
Not applicable to high-salt preserved food
People should be accompanied if unable to operate independently
The adapter is specialized. It is strictly forbidden to use other chargers for charging or use the
adapter to charge other devices
When charging, do not place any metal objects on the charging cradle
Reminders
Smell of bleaching powder in tap water may escape during the cleaning process, please rest
assured to use
It is strictly tested before delivery. If you find a tiny quantity of water remaining in the product
when the box is opened first time, please rest assured to use
H: Guarantee
The whole machine is guaranteed for one year free of charge (from the date of purchase on the invoice). Please refer to the sales platform
for services.
If any fault occurs during use and cannot be eliminated, please contact the seller for inquiries or warranty.
Following situations are not included into the scope of free services:
1. Correct purchase record or invoice cannot be presented.
2. Damage is caused by abnormal environment, accidental factors or improper use.
3. Damage is caused due to repair by yourself without permission of SORCERESSITA.
4. Product fault or damage is caused by natural disasters and other force majeure (such as earthquake, fire, lightning, etc.).
I: Packing List
Main body*1, Charging cradle*1, Charging adaptor*1, Instruction manual*1, Quick guide*1

J: Product Parameters
Product name
SORCERESSITA Food Ingredient Cleaner
Maximum output voltage
24V
Maximum output power
50W
Applicable water volume
3-6L
Dimensions
Φ6.02*1.57 inches
Net weight
1.32 pounds
Working temperature
+5C~+40°C
Waterproof Level
IPX7
Executive Standards
GB 4706.1 Part 1 of Safety of Household and Similar Electrical Appliances: General Requirements
GB 22747 Basic Concept for Food Processing Machinery: Hygienic Requirements
GB 4208-2008 Enclosure Protection Grade
Special Declaration
All contents in this document have been carefully checked. SORCERESSITA reserves the right of interpretation for any printing errors or
misunderstandings in the contents.
Any technical improvements in the product will be compiled into the new version of instructions without notice. The appearance and color of
the product may be changed, please subject to actual products.
Do not disassemble the machine by yourself. Please follow the maintenance procedures in the instructions for disassembly and maintenance.
Technology is Magic
www.sorceressita.com
Shenzhen Titan IoT Technology Co., Ltd
A-102-8B, Sci-tech Building, Phase II, 1057 Nanhai Avenue, Nanshan District, Shenzhen, China