Instructions for the SOTA Water Ozonator, Model WOZ5
• The SOTA units are consumer products designed to be used as part of a Wellness Lifestyle • The SOTA units are not medical devices nor are
they intended to diagnose, treat or cure any medical or health condition • The use, safety or effectiveness of the SOTA units has not been
approved by any government agency • Please consult a health practitioner for any medical or health condition. • Results using the SOTA
Products will vary for each person. • Please note that all purchases of SOTA Products are deemed to be made in Penticton, BC, Canada •
© 2012 SOTA Instruments Inc. Page 4 of 8 www.sota.com
4.Push the ON/OFF/TIMER button to turn the unit
ON. All the lights will ash in sequence to indicate
the unit is ready for use.
a. The unit starts with the 5 minute timer cycle.
b. If more than 5 minutes is required, push the ON/
OFF/TIMER button—each push moves the timer
from 15, to 30, to 60 minutes. A green ashing light
indicates which time is set. See page 6 for timing.
5.Check to be sure ne bubbles pass out of the Ceramic
Airstone into the water. If you do not see any
bubbles, ensure the silicone tubing is rmly attached
to the ozone outlet on the side of the unit. As the unit
operates, you should catch the smell of ozone.
6.At the end of a timed session, the unit will beep, all the LED lights will ash, and
the air pump will continue to operate for an additional 10 seconds to purge the
ozone from the tube. The unit will then turn itself OFF.
Allow water to drain from the tubing after use. This ensures water will not
drain back into the unit.
7.Use the freshly ozonated
water immediately for
optimal results. If left for
20 minutes in open air, the
ozone dissipates out of the
water and the benets of the
extra oxygen will no longer
be present.
8.To turn the unit OFF at any
time, hold the ON/OFF/
TIMER button down for a
full two seconds.
9.Turn the unit off and unplug
the wall adaptor when not
in use.
