Sound Tube RS31-EZ-T Configuration guide

Install Instructions For:
RS31-EZ(-T)
Box contents
©2012 SoundTube Entertainment, Inc. All rights reserved. PN INS-RS31-EZ Rev 03.20.19
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
RS31-EZ(-T)
Cover plate
Mounting plate
(shown with transformer)
Mounting screws (2)
Adjustment loop
Junction Box (not included)
Minimum internal depth: 1.5 inch (38.1 mm)
Speaker
1 Speaker assembly
2 Mounting screws
2 Wire Nuts
Safety leash

2. Feed signal wire from
ceiling through the mounting
plate via wire opening.
4. Screw mounting plate
into the junction box (not
included) using the mout-
ning screws provided.
5. Connect Signal wire into
terminal block
9. Excess wire can be
hidden inside of cover
plate by wrapping excess
wire clockwise and into
gap between plate and
surface
6. RS31-EZ-T wiring:
Connect the negative
signal wire to “com” and
the positive signal wire to
the desired power tap as
indicated.
7. Set speaker height by
adjusting speaker wire.
Push wire through the
central hole while pulling
on the center slack line to
shorten the speaker
hanging height. Reverse
to lengthen.
10. Completely thread
cover plate to secure
speaker.
Done.
8. Move cover plate up
speaker wire, begin to
thread cover plate into
mounting plate, leaving half
an inch between cover plate
and mounting surface.
Install Instructions For:
RS31-EZ(-T)
RS31-EZ(-T)
3. Where needed, connect
safety leash to secure
point on structure/junction
box.
1. Remove speaker from
box and unscrew the cover
to reveal the mounting
plate.

RS31-EZ(-T)
Install Instructions For 8 Ohm Bypass
3. Un-land the red and
black wires from the
terminal block and splice
in signal wires using wire
nuts.
4. Refer to steps 8-11 on
page 2 to complete
installation.
Done.
2. Remove the input
module mounted onto the
transformer. Unscrew to
remove the transormer.
+
-
1. Remove speaker from
box and unscrew the cover
to reveal the mounting
plate.