SOUNDMASTER URD810iPH User manual

DEUTSCH NEDERLANDS
ENGLISH ESPAÑOL
FRANÇAIS PORTUGUÊS
URD810iPH

1. Do not install this equipment in a confined or building-in space such as a book case or similar unit,
and remain a well ventilation conditions. The ventilation should not be impeded by covering the
ventilation openings with items such as newspaper, table-cloths, curtains etc.
2. WARNING: Only use attachments/accessories specified or provided by the manufacturer (such as
the exclusive supply adapter, battery etc).apply to adaptor
3. WARNING：Please refer the information on exterior bottom enclosure for electrical and safety
information before installing or operating the apparatus.(apply label on bottom)
4. WARNING：To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture. The apparatus shall not be exposed to dripping or splashing and that objects filled with
liquids, such as vases, shall not be placed on apparatus.
5. WARNING：For the terminals marked with symbol of “ ” may be of sufficient magnitude to
constitute a risk of electric shock. The external wiring connected to the terminals requires
installation by an instructed person or the used of ready-made leads or cords.
6. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
7. WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in
accordance with the installation instruction.
8. WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive
heat such as sunshine, fire or the like.
9.WARNING: The CRT in this apparatus employs a protective film on the face. This film must not
be removed as it serves a safety function and removal will increase the risk of serious injury.
12.This apparatus is for professional use only.
14.Explanation of symbol, marking, signal lamp or similar means indicate that apparatus is
completely disconnected from the mains.
15.No naked flame sources, such as lighted candles, should be placed on the apparatus.
13.When not in use and during movement, please take care of the power cordset, e.g. tie up the
power cordset with cable tie or something like that. It shall be free from sharp edges and the like
that can cause abrasion of the power cordset. When put into use again, please make sure the
power cordset being not damaged, If any damages found, please look for the service person to
replace the power cordset specified by the manufacturer or have the same characteristics as the
original one.
11.WARNING: The mains plug is used as disconnect device,
the disconnect device shall remain readily operable.
readily operable.
-- The all-pole mains switch located on front panel is used as the disconnect device, the switch
shall remain readily operable.
-- The all-pole mains switch and all-pole circuit breaker are not provided with the apparatus, the
installation shall be carried out in accordance with all applicable installation rules.
10.WARNING: Excessive sound pressure from earphones and headphones can cause hearing loss.
-- WARNING: Listening to music at high volume levels and for extended durations can damage
one’s hearing. In order to reduce the risk of damage to hearing, one should lower the volume to
a safe, comfortable level, and reduce the amount of time listening at high levels. Headsets should
comply with EN 50332-2 requirements (for GS certification)..
Correct Disposal of this product. This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
16.Attention should be drawn to environmental aspects of battery disposal.
17.Use of the apparatus in moderate climates.
18.
2

1
18
20
21
3
2
910
11
12
14
15
16
13
8
4
5 6 7
17
19
DIMMER

Press the MEMORY/CLOCK button for at least 2 seconds.
“12 HOUR” display with the digits 12 flashing. Press the
to set 24 hour mode.
6.
AUX
unit or
to confirm
to confirm
current clock displays.
4
mains plug.
mains plug
The clock can be synchronized automatically when inserting the
The clock will be 12 hour mode at the first synchronizing. If you want
to set 24 hour mode, please change the hour mode at clock setting
at STANDBY mode.
iPhone/iPod at the first time affer 60s. It can also be set later by
pressing and holding the SYNC/DISPLAY button at iPod mode
with iPhone/iPod docked when a time signal is received affer 60s.
dims
(0~30)

READ
READ
appears.
the display shows either current
track or elapsed play time.
with
5
CD
/MENU
/MENU
Pull the PULL OPEN position toward the way the arrowhead pointed
to open it.
Pull the CD door toward inside to close it.
outside
Repeat and Random
“REPEAT (Flashing)”
REPEAT (Flashing)
“REPEAT (Steadg)”
“RANDOM” appears
(Play tracks in a random way)
“RANDOM” appears
(Play tracks in a random way)
“REPEAT (Steady)” appears
(Repeat all track)
PLAY MODE
PLAY MODE
play
play
“REPEAT ”

64
64
CD
CD
CD
CD
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER -
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER

track
READ
CD MEMORY
CD MEMORY
CD MEMORY
CD
CD MP3 MEMORY
CD MP3
CD
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
CD
CD
MEMORY
MEMORY
CD
The first track of selected folder will display.
track

/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
The iPod/iPhone will be charged when the unit is powered on. It will
stop charging if the unit is set to Standby.
This unit operates with the below iPod/iPhone models:
Note:
Apple is not responsible for the operation of this device or its compliance with safety
and regulatory standards.
Please note that the use of this accessory with iPod or iPhone may affect wireless
performance.

AUX
2
TUNER
FM
TUNER
FM
TUNER MEMORY
MEMORY
FM
TUNER MEMORY
FM
MEMORY
CLOCK ADJ./MEMORY/ENTER
CLOCK ADJ./MEMORY/ENTER
unit
unit
Connect a stereo 3.5mm jack cable (supplied) between the
headphone or AUX output of the personal audio play and
the AUX IN jack on the rear panel.

120, 90, 60, 30 and 15
5
Press the "Alarm" button once, "Alarm" appears
ALARM
ALARM
ALARM
ALARM
TUNER
iPod
OFF
ALARM
alarm
alarm
6.
7. ALARM
ALARM
“ALARM”
alarm ALARM ALARM
ALARM ALARM
a available station
ALARM
ALARM
BUZZER
Note:
The Alarm function can be set at ON mode.

0.69
139(W) x 150(H) x 128(D) mm
8
100~230V 50Hz
Frequency response:
20Hz - 20KHz