Spectra T120 User manual

Service Procedure Quick Reference
Memory Card Replacement
T120
April 2017 V1
Page 1 of 2
Not a substitute for the official published procedural guide.
Detailed instructions/videos located at support.spectralogic.com
Tools & Supplies
New flash memory card from Spectra Logic
#1 Phillips screwdriver
USB flash drive (FAT32)
oWith saved library configuration and/or MLM/DLM database –if available
oFor collecting Auto-support Log File (ASL)
Estimated Time
20 Minutes
ESD Protection
Required
Library Power
Off
Data I/O Operations:
Discontinue
Verify with customer that data I/O to all drives has halted
Robotic Movement
Discontinue
Verify robotic movement has halted
Verify with customer that move requests from host have been halted
Admin./Superuser
BlueScale Login
Required
Considerations
It is recommended that all tapes are removed from drives by customer before
procedure to avoid potential stuck tapes after power-up
Verify customer has a current backup* of the following (if applicable):
oLibrary configuration
oMLM and DLM databases
oEncryption keys
*Due to high probability for corruption, it is not recommended to attempt backup of
library configuration, MLM/DLM database or encryptions keys if memory card being
replaced is faulty
Refer to “Spectra T120, T200, T380, or T680 Memory Card Replacement”
service guide for information that should be documented by customer prior to
service

Service Procedure Quick Reference
Memory Card Replacement
T120
April 2017 V1
Page 2 of 2
Not a substitute for the official published procedural guide.
Detailed instructions/videos located at support.spectralogic.com
Procedure Overview
1. Power off library
2. On the installed LCM, remove flash memory card cover
3. Eject card by pushing on the card until it clicks and is released from the slot
4. Insert new memory card into LCM. Push memory card in until it clicks
5. Replace flash memory card cover
6. Power on library
7. Calibrate front panel according to on-screen instructions
8. If available, restore previously saved library configuration and MLM/DLM database
from USB flash memory device
Insert USB flash memory device into any LCM USB slot
In BlueScale, login as superuser/administrator, navigate to and run the
following utilities:
Maintenance > Tools > Utilities > Show Advanced > Next > Restore Library
Configuration from USB > select library configuration file to restore from drop-
down list > Run Utility
Maintenance > Tools > Utilities > Show Advanced > Next > Restore MLM Database
from USB > select database file to restore from drop-down list > Run Utility
Remove USB flash memory device
If previously saved library configuration is not available, the customer must
manually reconfigure library (reference T120 User Manual)
9. Create an Auto-support Log File (ASL) and forward to Spectra Technical Support
Obtain permission from customer prior to performing this step
ASL’s do not contain sensitive customer information such as passwords,
encryption keys etc.
Reference knowledge base article KBA-02258 (Spectra Support Portal)
10. Old memory card can be discarded/destroyed