Spectra Stack User manual

SpectraLogic.com
Spectra Stack
Shipping Bracket Installation and
Removal Guide

December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 2
Copyright Copyright©2022SpectraLogicCorporation.Allrightsreserved.Thisitemandthe
informationcontainedhereinarethepropertyofSpectraLogicCorporation.
Notices Exceptasexpresslystatedherein,SpectraLogicCorporationmakesitsproductsand
associateddocumentationonan“ASIS”BASIS,WITHOUTWARRANTYOFANY
KIND,EITHEREXPRESSEDORIMPLIED,INCLUDINGBUTNOTLIMITEDTO
THEIMPLIEDWARRANTIESOFMERCHANTABILITYORFITNESSFORA
PARTICULARPURPOSE,BOTHOFWHICHAREEXPRESSLYDISCLAIMED.Inno
eventshallSpectraLogicbeliableforanylossofprofits,lossofbusiness,lossofuseor
data,interruptionofbusiness,orforindirect,special,incidentalorconsequential
damagesofanykind,evenifSpectraLogichasbeenadvisedofthepossibilityofsuch
damagesarisingfromanydefectorerror.
Informationfurnishedinthismanualisbelievedtobeaccurateandreliable.However,no
responsibilityisassumedbySpectraLogicforitsuse.Duetocontinuingresearchand
development,SpectraLogicmayrevisethispublicationfromtimetotimewithoutnotice,
andreservestherighttochangeanyproductspecificationatanytimewithoutnotice.
Trademarks BlackPearl,BlueScale,CC,RioBroker,Spectra,SpectraGuard,SpectraLogic,StorCycle,
TeraPack,TFinity,TranScale,andVailareregisteredtrademarksofSpectraLogic
Corporation.AttackHardened,EonProtect,andPreCalaretrademarksofSpectraLogic
Corporation.MigrationPassisaservicemarkofSpectraLogicCorporation.Allrights
reservedworldwide.Allothertrademarksandregisteredtrademarksarethepropertyof
theirrespectiveowners.
Part Number 90970045RevisionA
Revision
History Revision Date Description
ADecember2022 Initialrelease.

December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 3
Contacting Spectra Logic
To Obtain General Information
Spectra Logic Website: www.spectralogic.com
United States Headquarters European Office
SpectraLogicCorporation
6285LookoutRoad
Boulder,CO80301
USA
Phone:1.800.833.1132or1.303.449.6400
International:1.303.449.6400
Fax:1.303.939.8844
SpectraLogicEuropeLtd.
329DoncastleRoad
Bracknell
Berks,RG128PE
UnitedKingdom
Phone:44(0)870.112.2150
Fax:44(0)870.112.2175
Spectra Logic Technical Support
Technical Support Portal: support.spectralogic.com
United States and Canada
Phone:
TollfreeUSandCanada:1.800.227.4637
International:1.303.449.0160
Europe, Middle East, Africa
Phone:44(0)870.112.2185
Deutsch Sprechende Kunden
Phone:49(0)6028.9796.507
Email:[email protected]
Mexico, Central and South America, Asia, Australia, and New Zealand
Phone: 1.303.449.0160
Spectra Logic Sales
Website: shop.spectralogic.com
United States and Canada
Phone:1.800.833.1132or1.303.449.6400
Fax:1.303.939.8844
Email:[email protected]
Europe
Phone:44(0)870.112.2150
Fax:44(0)870.112.2175
Email:[email protected]
To Obtain Documentation
Spectra Logic Website: support.spectralogic.com/documentation

4
ROBOTICS SHIPPING BRACKET
INSTALLATION & REMOVAL
Thisdocumentdescribesinstallingandremovingtheroboticsshipping
bracketinaSpectraStacklibrary.Thebracketisonlyrequiredwhena
Stacklibraryisinstalledinadatacenterrackpriortoshipping.
Estimated Time = 5 - 10 minutes
BEFORE YOU BEGIN
Beforeinstallingorremovingtheshippingbracket,makesurethatyou
haveaddressedthefollowingrequirements.
Gather Materials and Tools
Required
A#1Phillipsscrewdriver
Asmallscrewdriver
Recommended
Ananti‐staticmat
Astaticprotectionwristbandorgroundingfootstrap
Ensure ESD Protection
Theinstallationenvironmentmustbefreeofconditionsthatcouldcause
electrostaticdischarge(ESD).ToprotecttheunitfromESD,followthese
procedureswhenrepairingortestingtheproduct:
Placeastaticprotectionmatontheworksurfaceusedwhileremoving
andinstallingcomponents.Usea1‐megohmresistortogroundthe
staticprotectionmat.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 5
Wearastaticprotectionwristbandorgroundingfootstrapwhenever
youhandlecomponentsthathavebeenremovedfromtheir
anti‐staticbags.Connectthewristbandtothestaticprotectionmatorto
othersuitableESDgrounding.
Note: Keepallelectroniccomponentsinanti‐staticbagswhennotin
use.
INSTALL THE SHIPPING BRACKET
Usetheinstructionsinthissectiontoinstalltheroboticsshippingbracket
intheSpectraStacktapelibrarypriortoshipping.
1. Removethetopcover.
a. Usingasmallscrewdriver,pressdownonthereleaselatchonthe
topofthechassisatthefront.
b. Slidethetopcovertowardsthefrontofthechassisuntilitcontacts
thescrewdriver.
c. Removethescrewdriverandslidethecoverforwardtoreleaseit
fromthechassis.
d. Liftthecoveroffandsetitaside.
Figure 1 Release the cover latch.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 6
2. Usinga#1Phillipsscrewdriver,removethetwoscrewsthatsecurethe
slot5drivebaycover.
3. Movethedrivebaycovertotheslot1positionatthebottomofthe
library.
4. Usinga#1Phillipsscrewdriver,installthetwoscrewsyouremovedin
Step2tosecurethecovertothechassis.
5. Locatetheshippinglockinsidethelibraryatthefrontofthechassis.
Figure 2 The rear of the Spectra Stack chassis.
Figure 3 The shipping lock.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 7
6. Tounlocktheshippinglock,fromthefrontofthechassis,slidethelatch
totheleft(1),pullthelatchtowardthefrontofthechassis(2),thenslide
thelatchtotheright(3).
7. Grasptheroboticmodulegentlybythesidesandpulluptoraisethe
roboticelevatorapproximatelyoneinch.
Figure 4 The shipping lock.
Figure 5 Grasp the robot as shown.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 8
8. Usingyourfingers,raisetheroboticelevatorusingthetwocutoutholes
onbothsidesoftherobotuntilitislevelwiththetopofthelibrary
chassis.Ittakesapproximatelytento15secondstoraisetherobotic
elevatorfully.
9. Whileholdingtheroboticelevatoratthetopofthechassis,installthe
roboticshippingbracketintheslot5drivebay(seeFigure2onpage6).
Note: Itmaybehelpfultohaveasecondpersoninstallthebracket
whileyouholdtheelevatorinplace.
10. Usinga#1Phillipsscrewdriver,removethetwoscrewsunderthe
handleoftheroboticshippingbracket(1)andinstallthetwoscrewsat
theendsoftheshippingbrackettosecureittothechassis(2).
11. Oncethebracketisinplace,releasetheelevatorandallowittoreston
theroboticshippingbracket.
Important
Do not raise the robotic elevator higher than the top of the chassis to avoid
disengaging the elevator from the track.
Figure 6 Use the cutout holes to raise the robotic elevator.
Figure 7 The robotics shipping bracket rear panel.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 9
12. Locatetheshippinglockinsidethelibraryatthefrontofthechassis.
13. Toengagetheshippinglock,fromthefrontofthechassis,slidethe
latchtotheleft(1),pullthelatchtowardtherearofthechassis(2),then
slidethelatchtotheright(3).
Figure 8 The shipping lock.
Figure 9 The shipping lock.

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 10
14. Positionthecoverovertheopeninginthechassissothatthetabsonthe
sidesofthecoveralignwiththeslotsinthechassis,andslidethecover
towardstherearofthechassisuntilitlocksinplace.
Figure 10 The top cover.

Remove the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 11
REMOVE THE SHIPPING BRACKET
Usetheinstructionsbelowtoremovetheshippingbracketafterthelibrary
isinstalledinthedatacenter.
1. Removethetopcover.
a. Usingasmallscrewdriver,pressdownonthereleaselatchonthe
topofthechassisatthefront.
b. Slidethetopcovertowardsthefrontofthechassisuntilitcontacts
thescrewdriver.
c. Removethescrewdriverandslidethecoverforwardtoreleaseit
fromthechassis.
d. Liftthecoveroffandsetitaside.
Important
You must remove the bracket prior to powering on the library to avoid an
initialization failure.
Figure 11 Release the cover latch.

Remove the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 12
2. Locatetheshippinglockinsidethelibraryatthefrontofthechassis.
3. Tounlocktheshippinglock,fromthefrontofthechassis,slidethelatch
totheleft(1),pullthelatchtowardthefrontofthechassis(2),thenslide
thelatchtotheright(3).
Figure 12 The shipping lock.
Figure 13 The shipping lock.

Remove the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 13
4. Usinga#1Phillipsscrewdriver,removethetwoscrewsthatsecurethe
shippingbrackettothechassis(2)andinstallthescrewsunderthe
handleoftheroboticshippingbracket(1).
5. Usingyourfinger,holdtheroboticelevatorinplace(seeFigure6on
page8)whileyoupulltheshippingbracketoutofthechassis.
6. Releasetheelevatorandallowittoslowlydescendtothebottomofthe
chassis.
7. Storethebracketandscrewsforuseifyouneedtomovethelibrary
afterinstallation.
8. Usinga#1Phillipsscrewdriver,removethetwoscrewsthatsecurethe
slot1drivebaycover.
9. Movethedrivebaycovertotheslot5positioninthelibrary.
10. Usinga#1Phillipsscrewdriver,installthetwoscrewsyouremovedin
Step8tosecurethecovertothechassis.
Figure 14 The robotics shipping bracket rear panel.
Figure 15 The rear of the Spectra Stack chassis.

Remove the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library 14
11. Replacethetopcover.
Note: ReplacingthetopcoverisonlynecessaryiftheStackbase
moduleisthetop‐mostchassisintherack.
a. Positionthecoverovertheopeninginthechassissothatthetabson
thesidesofthecoveralignwiththeslotsinthechassis.
b. Slidethecovertowardstherearofthechassisuntilitlocksinplace.
Figure 16 The top cover.