Spectrum Industries 37362 User manual

37362 - (1 desk) 37363 - (3 desks) 37364 - (5 desks) 37365 - (6 desks) 37366 - (10 desks) 37367 - (16 desks)
PART# ITEM
1 1 1 1 1 1 0192177 4-Pin Connector
1 1 1 1 1 1 0192178 6” Driver adapter
1 1 1 1 1 1 0192179 12 volt power supply
1 1 1 1 1 1 0192180 12” RGB F to M cable link
1 3 5 6 10 16 0192181 Plus shape connector
1 1 1 1 1 1 0192182 LED Controller
& RF Remote
- 2 4 5 9 15 0192183 72” Interconnection cable
1 3 5 6 10 16 0192272 6” Interconnection cable
1 3 5 6 10 16 0192184 12” RGB LED Tape light
1 3 5 6 10 16 0156657 LED Light bracket
2 6 10 12 20 32 0101911 #14 x 3/4” PHSM
Assembly InstructionsAssembly Instructions
0192185R1 Page 1 of 2
Assembly Instructions
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
LED Lighting Kit for Esports Desks
37362 - (1 desk)
37363 - (3 desks)
37364 - (5 desks)
37365 - (6 desks)
37366 - (10 desks)
37367 - (16 desks)

2
1Attach LED light bracket 2Apply LED tape to bracket
3Connect LED components
0192185R1 Page 2 of 2 © 2022 Spectrum Industries Inc., All rights reserved.
1500 RIVER STREET, PO BOX 400, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
1. Attach the LED light bracket centered under the
worksurface with (2) #14 x 3/4” PHSM screws. Figure 1.
1. Connect the components under the worksurface as shown while
routing them through the desk cord channel. Figure 3.
(Note plus connector and LED tape will not go in the cord channel.)
Worksurface
Figure 2
LED light
bracket
#14 x 3/4” PHSM
(2 required)
Figure 1
12” LED
tape strip
4” LED
light tape
Connectors
toward cord
channel
LED light
bracket
Cord channel
Figure 3
4-pin connector
4” LED tape 4” LED tape
Plus connector
LED Controller
(connect to power
strip or wall outlet)
6” Driver
adapter
12” RGB
F-to-M link
72” interconnection cable
to plus connector on next desk
LED light
bracket
6” Interconnection cable
Cord channel
1. Applythe12”LEDtapestriptothebracketangeswiththe
connectors pointing toward the cord channel. Figure 2.
12V Power supply