
Location – Fly in a wide-open room away from breakable items. Avoid flying near vents and/or fans, as
these may overpower the
GRAVITOR™
and make it difficult to control.
a
CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body
parts. Never hold the flying vehicle in your hand when lifting off. DO NOT launch vehicle near people or
animals. Stay away from obstacles and electrical hazards.
For TROUBLESHOOTING questions and solutions,
please visit our website: AIRHOGS.COM/GRAVITOR
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the
issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to
another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full
function.
Safety Precautions: - Keep hands, hair and loose clothing away from the rotor when power switch is turned ON. - Parental
guidance is recommended during play. - Keep your toy in your sight so that you can supervise it all the time. - Users should
keep strict accordance with the instruction manual while operating the product. Under the environment with electrostatic
discharge, the toy may malfunction and require user to reset the toy.
CARE AND MAINTENANCE: Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat.
Do not submerge the toy in water. This can damage the electronic assemblies.
CONTAINS 1 X 3.7V 200 mAh LiPo BATTERY PACK
.
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end
of its useful life, it should not be disposed of with other household waste. The Waste Electrical and Electronic
Equipment Regulations require it to be separately collected so that it can be treated using the best available
recovery and recycling techniques. This will minimize the impact on the environment and human health from
soil and water contamination by any hazardous substances, decrease the resources required to make new products and
avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie
bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product
to your retailer when you buy a similar new one. For other options, please contact your local council.
SPECIAL LiPo BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated area. Keep
away from flammable materials. - Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or
igniting. - Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot
places. - Do not drop or subject to strong impacts. - Do not allow the batteries to get wet. - Only charge the batteries with the
specified Spin Master™ battery charger. - Only use the batteries in the device specified by Spin Master™. - Carefully read the
instruction guide and use the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire
extinguisher for the battery. - Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable. Product
disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product
during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves
to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap
the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of
the product. Dispose of battery in accordance with your local battery recycling or disposal laws.
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for
Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does
cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the
interference), one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna.
• Increase the separation between the toy and the radio or the TV.
• Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter
component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be
expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc.,
PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit
fcc.spinmaster.com
Do not change or modify anything on the toy.
a
WARNING: IF ROTOR(S) BECOME DAMAGED OR BROKEN, DO NOT FLY. FLYING WITH BROKEN ROTOR(S) MAY
CAUSE DAMAGE OR LEAD TO INJURY.
BEFORE FIRST USE: Read the user's information together with your child.
a
WARNING: CHOKING HAZARD – Small parts. Not for children under 3 years.
T44363_0161_20130477_GEN_IS_R5
AIRHOGS.COM/GRAVITOR
For in-depth video instructions go to
NORTH AMERICA – 1-800-622-8339
customercare@spinmaster.com
UK – 0800 206 1191, serviceuk@spinmaster.com
IRELAND – 1800 992 249
AUSTRALIA –1800 316 982, customercare@spinmaster.com
WWW.SPINMASTER.COM
65 7 8
Low battery indication - LED will flash and the
GRAVITOR™ will fly low. Recharge for best play
experience.
5. PASSING:
Hold the GRAVITOR™ by the trick stick and
tip forward 10-30°. Pass gently to another
player.
6. When finished playing, move the power
switch on the GRAVITOR™ to OFF.
5 6
If the GRAVITOR™ has a hard crash, the motors
will turn off. You will need to turn it OFF and
back ON to restart it.
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St Leonards, NSW 2065; 1800 316 982
Spin Master Toys UK Ltd. Secure Trust House, Boston Drive, Bourne End, Buckinghamshire, SL8 5YS, UK
Spin Master logo & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future
reference. Content may vary from pictures. Keep away from obstacles and electrical hazards. Spin Master Ltd. reserves the
right to discontinue the www.AIRHOGS.com/GRAVITOR website at any time.
MADE IN CHINA
------------------------------------------------------------------------------------------------------------------------------------------------
10˚
10˚
30˚
30˚
TROUBLESHOOTING
This toy is only to be connected to equipment bearing either of the following symbols:
or
Country of Origin - Placement
Factory according to production country to print Country of Origin (COO)
If corresponding country is not in below, contact Spin Master to provide translation
China Mexico
Vietnam India
Country of Origin
Placement
MADE IN CHINA
MADE IN INDIA
MADE IN VIETNAM
MADE IN MEXICO
• This contract proof is simulated ISO-G7 printing on CCNB.
• CMYK color on printing must closely matching to this sheet.
• Pantone color must closely matching to Pantone book.
• Print sample standard viewing condition is 5000°K light booth.
• Screen ruling 175 lpi or above.
• Die-line may slightly dierent from latest development, check with product
vendor or Spin Master.
• Die-line, placement line and placement indicator do not print.
Black
Eect
Production Notes
Artwork serial (docket) :
T44363_0161_20130477_GEN_IS_R5(ARH_Gravitor_F21)
Visual Branding Designer / Date:
Jason Hu (03-15-2021)
CONFIDENTIAL / UNAUTHORIZED USE PROHIBIT