Sport-thieme 122 4375 Product guide

Operating/assembly instructions
Free-standing ballet barre
Prod. code: 122 4375
Page 1of 3
02/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
Assembly instructions for the free-standing ballet barre
Thank you very much for choosing a Sport-Thieme product. We want to make sure
that you can enjoy this product, so here is some important advice for your safety as
well as for the use and maintenance of the equipment.
Please read these instructions fully before you assemble and use the equipment.
Included:
Illustration 1: Free-standing
ballet barre
Pos. Description
1 4 x hex screw M10 x 35, with spring washer and cap nut
2 2 x base with rubber feet
3 2 x lower post
4 1 x cross strut with 4 x setscrew M8 x 16
5 2 x clamping lever
6 2 x upper post
7 1 x ballet barre, L = 2.00 m, Ø= 4.0 cm, with 4 wood screws 5 x 25
8 1 x hex key SW3 and SW4
1. General
The free-standing ballet barre's height can be freely adjusted between 85 and 110
cm. Using a clamping system, any height in-between can be set. Please ensure
that the barre is horizontal.
The free-standing ballet barre is only suitable for its intended use. Improper use
voids the warranty. Make sure you do not put too much weight on the barre and it
does not tip over.
This is a mobile piece of equipment that is not fixed to the floor!

Operating/assembly instructions
Free-standing ballet barre
Prod. code: 122 4375
Page 2of 3
02/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
2. Assembly instructions
First, connect the base !and the lower post"using the hex screw, spring washer
and cap nut #from underneath.
Next, place the parts #to "upright as shown in ill. 2 and place the cross strut $on
top from above.
In order to ensure stability, mount the cross strut $roughly in the middle of the
lower post "(see ill. 1)!
Now place the 2 clamping levers %in such way on the top of the lower posts "
that the levers are on the outside to ensure easier operation.
Fix the clamping levers to the lower posts "using the included hex key.
The two upper posts &are now placed into the clamping levers %and fixed at the
same height.
Finally, push the ballet barre 'from one side into the upper posts &. The barre 'is
centred and fixed from underneath using the wood screws included (see ill. 3).
' &
%Illustration 3:
Mounting
ballet barre
$
"
!
#
Illustration 2: Exploded view
drawing
Illustration
4: Mounting
cross struts

Operating/assembly instructions
Free-standing ballet barre
Prod. code: 122 4375
Page 3of 3
02/2016
!
!
38367 Grasleben / Germany
Telephone: [phone]
!!!"#$%&'(')*+,+"-%,.
Caution: Do not overload or climb the equipment!
Maintenance and care instructions
Instructions: Carry out a visual check at regular intervals. Due to our
continuous quality control of the products, technical changes
may occur which may lead to slight deviations in the
instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace
worn-out parts. Check the condition of wooden elements
as chipping and other signs of wear can result from use.
We are happy to answer any questions you may
have.
Your Sport-Thieme Team