Care and maintenance
Always wipe off the mini-roller after use to avoid any corrosion
to the parts. Use a damp cloth only; do not use any cleaners.
You may notice that magnetic particles may stick to the red
drum. No worries, just remove big stuff (paperclips) by hand,
and remove small dusty iron parts with the sticky side of a piece
of tape.
The bearings are permanently lubricated and sealed. No
maintenance is required on the bearings.
Keep all fasteners snug & tight, but do not overtighten.
Warranty
SportCrafters warrants your mini-roller to be free of any and all
defects in material or workmanship. This warranty does not
apply to parts that have been worn out through normal use, or
damaged through misuse, abuse, neglect, accident, or acts of
God. Where applicable, incidental and consequential damages
are not covered, and there are no other warranties, expressed or
implied, This warranty applies to the original owner, and is valid
for a lifetime of ownership.
Please retain your receipt as proof of purchase.
If anything goes wrong during the warranty period, please
MINI-ROLLER MANUAL
With Magnetic Resistance (MR100)
Or Progressive Magnetic Resistance (MR110)
Congratulations on your purchase of a SportCrafters mini-roller.
This unit was designed to provide the best workout possible and
let you train with your trike without fear of damaging the frame
or wearing tires. Your mini-roller features:
Powder coated tubular steel construction
100% sealed radial ball bearings
Two large 3” diameter aluminum drums provide a
smooth ride without tire wear.
Model MR100: One drum with two red caps
Provides a good nominal resistance for most cyclists
Model MR110: One drum with red and black cap.
Provides higher resistance at higher speeds for more
accomplished athletes. Equipped with
It is also 100% made by hand in the U.S.A.
www.sportcrafters.com
