SportsPlay Equipment 561-505 User manual

561-505 Junior Soccer Goal (Pair) Page 1 of 1
Rev 04/04/03
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
* IMPORTANT *
PLEASE RETAIN THIS INSTRUCTION SHEET IN YOUR FILES. IT CONTAINS IMPORTANT REPLACEMENT
PARTS INFORMATION. ALL EQUIPMENT SHOULD BE INSTALLED IN ACCORDANCE WITH THESE
INSTRUCTIONS.
IT IS IMPORTANT TO USE AND MAINTAIN ALL PUBLIC PLAYGROUND EQUIPMENT PROPERLY. PLAYGROUND
EQUIPMENT, WHICH IS IMPROPERLY MAINTAINED, CAN CAUSE SERIOUS INJURY. PERIODICAL
INSPECTIONS, MAINTENANCE, REPAIR AND/OR REPLACEMENT OF DAMAGED PARTS IS NECESSARY FOR
SAFE OPERATION OF EQUIPMENT AND SAFETY OF USERS. RESILIENT SURFACING SHOULD BE USED
UNDER ALL PLAYGROUND EQUIPMENT. APPROPRIATE PUBLICATIONS, AVAILABLE AT NO CHARGE, FROM
THE CONSUMER PRODUCT SAFETY COMMISSION, INCLUDE “A HANDBOOK FOR PUBLIC PLAYGROUND
SAFETY.” YOU CAN RECEIVE YOUR FREE COPY BY CALLING 1-301-504-7908.
PACKING LIST HARDWARE BAG
1 CTN Hardware Bag 4 105-017 2 3/8” Pipe Plug
4 PIPE 1 563-604 Net Support Posts 4 pr 425-517 1 7/8” T-Clamps
4 PIPE 1 563-215 Goal Post 4 116-511 5/16” x 1 ¾” Hex Head Bolt
4 WF 1 563-314 Cross Frame 16 196-802 ½” x ½” Socket Set Screw
4 PIPE 1 596-614 Post Support 6 116-604 338” x 1” Hex Head Bolt
6 226-601 3/8” Lock Nut
4 226-501 5/16” Lock Nut
1 416-400 ¼” Socket Key
1 CTN 4 PIPE 5 TOTAL PCS WT 110# CLASS 70

561-505 Junior Soccer Goal (Pair) Page 2 of 2
Rev 04/04/03
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
NOTE: All threaded ends of bolts protruding beyond nuts must be
cut off and/or peened to eliminate sharp edges. No more
than two threads should extend beyond face of nut.
All washers, “T” nuts, and other fastener hardware used on
round pipe or tubing must be hammered down to conform to the
curved underlying surface to eliminate catch points.
DO NOT tighten nuts more than hand-tight until entire
assembly is completed.
STEP #1: Assemble goals on the ground before digging footing holes
STEP #2: Attach uprights to tip rail with elbows. Tighten in place
with set screws
STEP #3: Attach Net Support/Backstays with T-Clamps. Do not tighten
T-Clamps.
STEP #4: Stand goals upright. Tighten T-Clamps. Set in place. Mark
footing hole positions. Move aside and dig footing holes.
STEP #5: Position goal in footing holes. Use ships, braces, etc. to
level and hold in place. Pour concrete. Crown footings 2-
3” below playing surface. Let set 24-48 hours before use.
STEP #6: Attach net. Full size regulation net doubled over can be
tied to posts using string or plastic ties.
MAINTENANCE INSTRUCTIONS:
Check periodically for loose bolts, broken parts and replace immediately.