8’ Standard Bench with Back
Perforated-Beveled Edge-Portable Frame
Please keep a copy of these instructions in your files. There is
important replacement part information in them that will assist
you in the event a part is ever needed.
Verify that all parts were received by comparing the parts
received to the component list on page one.
If your product mounts to something (surface mount, in ground
or wall mount) you will typically assemble the product before
drilling or digging holes in order to ensure proper layout.
CONTACT YOUR DISTRIBUTOR ABOUT ANY PARTS YOU ARE
MISSING. You must report missing parts within 10 days of
delivery.
Hand-tighten all bolts during the initial assembly (unless
specifically told to tighten completely in the instructions). Once
the unit is fully assembled and square you should completely
tighten them.
Other than when a specific step in the assembly instructions
specifies “to not apply lock tite (8)”, we recommend applying a
small amount to all assembly bolts.
General Maintenance
It is recommended that you inspect the product monthly for
loose bolts and broken parts. If replacement parts are needed
please refer to these instructions for part numbers and
descriptions then call your distributor to order replacements.
1. Attach one of the Bench Planks (1) to one of the Bench Legs (2)
by inserting two 3/8” x 3” Button Head Bolts (3) and 3/8” Washers
(4) through the bottom of the Leg and into the factory installed
nuts on the mounting plate attached to the bottom of the Bench
Plank (Detail A)
2. Following the same procedure established in step 1, attach the
same Bench Plank (1) to the second Bench Leg (2) using two 3/8” x
3” Button Head Bolts (3) and 3/8” Washers (4).
3. Attach the second Bench Plank (1) to the Bench Legs (2)
following the procedures outlined in steps 1 & 2 (the second Bench
plank is the back rest). Once the second Bench Plank is attached
the unit will look like Detail B.
4. After you have completed steps 1-3, square the unit using a
level and tighten the bolts using the 7/32 Allen Wrench (5).
Ve
