SRS Lighting DSR10ABN User manual

( 1 / 1)
Instruction Manual
Models:
version 1.0 since 19 June 2017
ATTENTION!
This instruction manual contains important information about the installation and the use of
the equipment. Please read and follow these instructions carefully.
Always ensure that the power to the equipment is disconnected before opening the
equipment or commencing any maintenance work.
SR10ABN_en_manual_M065
10
-
ay DMX Split
ter
ith
A/B Line Selection
DSR10ABN

( 2 / 2)
IMPORTANT SAFETY INFORMATION
The following general safety precautions have to be observed during all phases of operation,
service, and the repair of this equipment. Failure to comply with these precautions or with
specific warnings in this manual violates safety standards of design, manufacture, and intended
use of this equipment.
Do not operate in an explosive atmosphere!
o not operate this equipment in the presence of flammable gases or fumes. Operation of any
electrical instrument in such an environment constitutes a definite safety hazard.
Water, moisture, heat and humidity
o not operate this equipment near water or in areas with wet floors or in high humidity
atmosphere where condensation forms on the equipment. It should never be placed near or over
a heat register or other source of heated air and it should not be installed or operated without
proper ventilation.
DMX connections
MX 3-/5-pin or RJ45 connectors are located on the front panel of the device. They are
separated into two groups. The 1
st
group is marked as inputs A and B. This line should be
terminated by the termination switch marked “120R”. When the line is terminated by a 120R
resistor, the red indication LE is on.
The other group consists of 10-way optically/electrically isolated lines marked with numbers 1 to
10. Each line has a separate A/B source selection, power supply and a bus line driver + indication
of signal on both signal lines with two LE s indicating the polarity of the MX signal.
Pin 1 Ground / Common
Pin 2 ata -
Pin 3 ata +
Pin 4, 5 NC
Pin 1, 3 ata+
Pin 2, 6 ata -
Pin 4, 5 NC
Pin 7, 8 Ground / Common

( 3 / 3)
Controls and indication
1. MX input signalization
2. MX input connector channel A
3. Termination switch + indication
4. A/B channel selector switch
5. MX output data signalization
6. MX output connector
Device Design
Front panel:
Rear panel:
Device se/servicing:
The ON LE indicator indicates the device is on the main power. All other data indication LE s
being off mean no incoming signal. The termination LE s are on when the termination switch is
activated. The desired MX source to be retransmitted on each output can be selected using the
A/B switches close to the output connectors.
When the MX cable is connected to the device, all LE s marked as +/ - or the sign of signal
polarity go on. This indicates that SR10ABN is functioning properly and is retransmitting the
input to the outputs. If any of LE s is off, check the cable first – short circuit on a line causes
the respective LE is off.

( 4 / 4)
Technical data
Main inp t:
AC 100-255V / 50-60Hz / 15W
Inp t/O tp t:
2x USITT MX512
10x USITT MX512 amplified
Size:
1U, 19’’ format / 482,5 x 44,5 x 130 mm
Weight:
2.1 kg
DECLARATION OF CONFORMITY
According to g idelines 89/336 EEC and 92/31 EEC:
Name of prod cer: SRS Group s.r.o.
Address of prod cer: Rybnicna 36/ , SK- 83106 Bratislava, Slovak Republic
Declares that the product
Name of prod ct: 10-way MX splitter with RJ45 connectors
Type: SR10ABN
Corresponds to the following product specifications:
Safety: EN60065, resp. EN 60950
EMC: EN55103-1, resp. EN55103-2
Additional information:
Unit and all connected apparatuses must be earthed via main cable.
Bratislava, 10 May 2009
Robert Sloboda
Copyright 2017 SRS Group, s.r.o. | Specifications subject to change without notice.
ocument: SR10ABN_en_manual_M065 | Version 1.0 | Actual as of: 19 June 2017
SRS Gro p s.r.o.
Rybnicna 36/ | 831 07 Bratislava | Slovakia
Phone: [phone] | Fax: [phone]
Email: [e-mail] | www.srs-group.com
Package consists of:
•SR10ABN,
•1.5m 3G0.75mm2 PowerCon
cable,
•Printed manual
Warranty:
Life-time warranty