Standard AccuBind Pro User manual
AccuBindProTM
UNPACKING AND INSTALLATION INSTRUCTIONS
Read all instructions before proceeding!
PACKING LIST
1. 1 each AccuBindPro
2. 1 each Cooling Rack
3. 1 each Pressure Block
4. 1 each Power Cord
5. 1 each Rear Book Support
6. 1 each Front Book Support
Customer Requirements
Table or stand capable of supporting approx.
100 lbs of machine, accessories and materi-
als.
120 Volt, 10 amp, grounded receptacle within
five feet of machine work area.
AccuBind™Binding Strips (purchased sepa-
rately).
1
2
4
5
6
3
Place carton a flat
level surface, with the
arrows pointing
upwards.
Remove tape from
top of carton and
open flaps.
Remove top card-
board sheet to
expose accessories.
Remove ceneter
foam panel that holds
accessory items.
Lift machine by
grasping front and
rear as shown.
A second person
should hold the pack-
ing carton in place so
that machine can be
lifted easily.
While holding
machine steady, slide
off the foam protec-
tors from each end.
Remove protective
plastic wrapper.
Insert the rear book
support. Insert the front book
support. Connect the power
cable to the machine. Connect the other
end of the power
cord to the wall out-
let.
Place cooling rack on
the work surface near
the machine.
Place the pressure
block on the cooling
rack so that the
beveled edge is fac-
ing up and to the
rear.
Switch the main ower
switch on to the “I”
position.
When all of the tape
size indicators A-F
are unlit, press the
green “start button.
Other manuals for AccuBind Pro
2
Other Standard Binding Machine manuals
