Star Micronics TMP900 Installation instructions manual

Mounting the Paper Guide Plate and Assist Guide
1. Opening the Package : Check that all of the accessories are included.
2. Mounting Procedures:
2-1 Mounting the Paper Guide Plate
Fasten the paper guide plate to the printer
mechanism using the two screws.
2-2 Mounting the Assist Guide
The paper guide plate has four grooves for 112 mm and 80 mm width paper.
Set the assist guide into the grooves for the size of paper to be used.
1Insert the hooks of the assist guide into the left side mounting grooves.
Slide the guide downward to fasten.
2Insert the hooks of the assist guide into the right side mounting grooves.
Slide the guide upward to fasten.
Note: When the assist guide is mounted to the 80 mm position, adjust the
side guide for use with the 80 mm assist guide.
Assist guides
side guide 80 mm
Mounting Grooves
112 mm
Mounting Grooves
80871440 TMP9-PGU
Paper guide plate
M3 ×6 screws
(For Mounting of the Paper Guide Plate)
Hooks