Star RFL100C User manual

Quick Installation Guide STAR
RFL100C/200C
IDTECK 20040609
1/4
1. Check Environment
1.1 Check the power source
Before connecting, check the input voltage if it is right as DC12V/150mA.
1.2 Connection Diagram
1.5 Interface controller required, Event management and Lock control (Over 16 units)
1.4 Lock control and event Management
(
U
p
to 16 units
)
1.3 Lock Control only without event management
(Max. 255)

Quick Installation Guide STAR
RFL100C/200C
IDTECK 20040609
2/4
2. Setup Hardware
- All the parameter of RFL100C/200C was set-up by Software.
2.1 Address Setting
-Select and type the name from the keyboard.
2.2 In/Out point relation definition
2.3 User registration/deletion
Cardholder registration/deletion has been
performed by the software.
2.4 System Initialization
RFL100C/200C initialized by the software.

Quick Installation Guide STAR
RFL100C/200C
IDTECK 20040609
3/4
4. Normal Operation
Power on
When the power is applied to RFL100C/200C, Red LED will be light on. The initial beep should sound twice.
Registered card reading
When a registered card is read, the Door will be opened for 3 seconds (Default) with the Green LED light on.
Unregistered card reading
When an unregistered card is read, the access is denied and the beep sounds twice.
Exit Button
The Exit Button can be used to exit the door.
Press the Exit Button
The Door will be opened for 3 seconds with the Green LED light on.