Starkey TV Streamer User manual

Volume up
Power on/off
Pair
Volume down
Pairing
The TV Streamer must be paired to interact with compatible 2.4 GHz hearing aids on the Thrive platform.
Pairing occurs once, then the hearing aids and TV Streamer will automatically recognize each other.
1Power off your smart device or other accessories
that were previously paired with your hearing aids.
2Ensure the TV Streamer is powered on.
3Power off, then power on your hearing aids to
place in pairing mode.
4Place your hearing aids within 6 inches
of the TV Streamer.
5Press the pairing button on the TV
Streamer to place in pairing mode.
The LED will rapidly blink blue.
6Once the LED blinks green
for each hearing aid, both
hearing aids are paired.
Basic Setup
5
TV Streamer
A B C D
Power Supply Jack (microUSB)
A
Toslink Jack
B
Analog 3.5mm Jack
C
Mono/Stereo Switch
D
1Remove the plastic caps from each end of the
TOSLINK cable.
2Plug the TOSLINK cable into the Audio OUT
jack of your television. If there is no TOSLINK
audio OUT jack, use a 3.5mm to RCA cable.
3Power on your television.
4Plug the other end of the TOSLINK cable
into the rear of the TV Streamer B.
5Insert the power adapter microUSB connector
into the rear of the TV Streamer A.
6Plug the power adapter into the wall socket.
7Turn on the TV Streamer. A solid green LED
indicates power is on.
8A solid blue LED indicates the TV Streamer
has detected audio and is streaming.

1Double Tap feature only available on AI products. | The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Starkey is under license.
Amazon Echo and Echo Dot and all related logos and motion marks are trademarks of Amazon.com, Inc. or its affiliates. | Thrive, Starkey and the Starkey logo are trademarks of Starkey Laboratories, Inc.
©2021 Starkey. All Rights Reserved. 3/21 FLYR3469-04-EE-GS
Use
• An unlimited number of 2.4 GHz hearing aids can connect to the TV Streamer at one time, allowing multiple
people to share in the same listening experience.
• The TV Streamer can be successfully connected to many electronic audio sources including televisions, computers,
MP3 players, DVD players, cable boxes, Bluetooth®or AmazonEcho and Echo Dot (3.5mm Jack).
• To adjust the stream volume, press the + or - buttons on the TV Streamer. Volume can also be adjusted via the
hearing aid user controls, the Remote Control accessory (if applicable) or in the Thrive Hearing Control app.
Audio streaming may be started/stopped in several ways:
To start/stop the audio stream, double tap your hearing aid.1You can also start/stop the audio stream via the
push & hold hearing aid user control (if enabled by your clinician), the Remote Control accessory (if applicable)
or in the Thrive Hearing Control app.