StarTech.com S2510U33RUSM User manual

Manual Revision: 08/07/2013
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
S2510U33RUSM
SATA USM™ Bay with USB 3.0 SSD/HDD Enclosure
*actual product may vary from photos

Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.

Instruction Manual
i
Table of Contents
Product Diagram ....................................................................................1
Front View .................................................................................................................................................... 1
Rear View...................................................................................................................................................... 1
Introduction............................................................................................2
Packaging Contents ................................................................................................................................. 2
System Requirements.............................................................................................................................. 2
Installation ..............................................................................................3
Hardware Installation .............................................................................................................................. 3
Hard Drive Installation............................................................................................................................. 4
How to Use .................................................................................................................................................. 6
Initializing the Hard Drive ...................................................................................................................... 7
Technical Support ..................................................................................8
Warranty Information............................................................................8

Instruction Manual
1
Product Diagram
Front View
Rear View
Drive Eject
Button
Drive
Slot
SATA Data
Port
SATA Power
Port
Optional LP4
Power Port

Instruction Manual
2
Introduction
Packaging Contents
• 1 x USM 5.25” Installation Bay
• 1 x 2.5” HDD Enclosure
• 1 x USM to USB 3.0 interface adapter
• 1 x USB Micro USB Cable
• 1 x Installation Screw Kit
• 1 x Instruction Manual
System Requirements
• 1 x Computer System with SATA connectivity and an available 5.25”bay
• 1 x SATA Data Cable
• 1 x Available SATA or LP4 Power Connection
• 1 x 2.5” SATA Hard Drive
WARNING! Hard drives and storage docks require careful handling, especially when
being transported. If you are not careful with your hard disk, lost data may result.
Always handle your hard drive and storage device with caution. Be sure that you
are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.

Instruction Manual
3
3. Hold the S2510U33RUSM into place, and x the included 8 screws (4 per side)
through the installation holes on the 5.25”slot, into the side installation holes on the
S2510U33RUSM.
4. Connect a SATA Data cable from your computer motherboard to the SATA DATA port
on the back of the S2510U33RUSM.
5. Connect either a SATA Power Cable or an LP4 Power Cable from your computer
power supply, to the SATA Power port or LP4 Power Port respectively, depending on
your power cable availability.
Installation
Tray Installation
1. Ensure your computer system is powered down, and the power cable has been
disconnected from the Power Supply.
2. Open your computer case (refer to the computer user manual for details), and
place the USM 5.25 Installation Bay into an available 5.25” slot, lining up the side
installation holes on the S2510U33RUSM (pictured below), with installation holes on
the 5.25” slot inside the computer.

Instruction Manual
4
4. Install the tray back into the housing and replace the back plate ensuring that the
plate is aligned to the SATA connector.
5. Fix the two screws on the SATA plate back into place.
Interfacing with S2510U33RUSM 5.25” Installation Bay
Mount Drive
With the USB 3.0 to USM adapter removed from the S2510U33USM USM Enclosure,
gently slide the USM Enclosure Drive into the slot provided by the 5.25” USM drive tray
(S2510U33RUSM), until you feel full resistance.
Remove Drive
Press the drive eject button on the 5.25” USM drive tray (S2510U33RUSM). The USM
Enclosure will slide away from the installation bay slightly. Grasp the Enclosure with
your ngers and slide the drive the rest of the way out.
NOTE: It is important to eject or unmount the hard drive from your computer system
before physically removing the drive. See How to Use - Disconnecting the Hard Drive
section for instructions.
2. Slide the inner tray forwards out of the housing.
3. To install the hard drive start by placing one side into the tray then lower the other
size into place until the drive snaps into place.
Drive Installation
1. With the USB 3.0 to USM adapter removed from the S2510U33USM USM Enclosure,
remove the two screws on either side of the USM port, to remove the SATA plate.

Instruction Manual
5
Interfacing with USB Controller
1. Connect the USM to USB 3.0 interface adapter to the enclosure through the USM
port.
2. Connect the USB 3.0 cable from the USB port on the adapter to an available USB 3.0
port on your computer system.
How to Use
Connecting the Hard Drive
Once the enclosure has been attached to a computer, the drivers will install
automatically, and the inserted drive will be accessible as though it were installed
within the system.
Prior to using the drive, it will need to be formatted according to your operating
system requirements. Refer to Initializing the Hard Drive
Disconnecting the Hard Drive
Windows
1. Select the “Safely remove Hardware and Eject Media” icon, located in the task bar.
2. Select the Mass Storage Device from the list that appears.
3. Wait for the message indicating that it is now safe to remove the device.
NOTE: Removing the connected drive prior to receiving notication that it is safe
to do so, could result in losing or corrupting data stored on the drive. Once the Safe
to Remove Hardware message appears, please disconnect the enclosure from the
computer by removing the USB connection.
Mac OS X
To safely disconnect the attached drive from the host computer, close any windows
listing the contents of the removable drive. Once all windows are closed, click on the
USB storage icon on the desktop, and drag it to the Trash Can icon on the desktop.
Allow 5 seconds before physically removing the enclosure/drive from the computer.

Instruction Manual
6
2. A dialog window should automatically appear, asking you to initialize the drive.
Depending on the version of Windows, it will give you the option of either creating
an “MBR” or“GPT” disk. GPT (GUID partition) is required for drives larger than 2TB but
is not compatible with some older operating systems, while MBR is supported by
newer and older operating systems.
3. Once initialized, locate the Disk that says it is “Unallocated” (check the listed hard
drive capacity to conrm it’s the correct hard drive) and then right-click in the
section that says “Unallocated” and select “New Partition”.
Initializing the Hard Drive
1. If the SATA Hard Drive is blank it may need to be initialized and formatted before
use. From the main Windows desktop, right-click on “My Computer” (“Computer” in
Vista/ 7 / 8), then select Manage. In the new Computer Management window, select
Disk Management from the left window panel.
4. Several on screen prompts will follow walking you through the steps to create the
partition. Follow these prompts to complete partition creation.

Instruction Manual
7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.

Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.