StarTech.com IES51000POE User manual

Manual Revision: 07/09/2013
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
IES51000POE
5 Port Gigabit Industrial Power over
Ethernet Switch with 4 PoE ports
*actual product may vary from photos

Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.

Instruction Manual
i
Table of Contents
Product Overview ..................................................................................1
Front View................................................................................................1
Rear View...................................................................................................................................................... 1
LED Indicators............................................................................................................................................. 1
Introduction............................................................................................2
Packaging Contents ................................................................................................................................. 2
Installation ..............................................................................................3
Wall-Mounting ........................................................................................................................................... 3
Hardware Installation .............................................................................................................................. 3
Specications..........................................................................................4
Technical Support ..................................................................................5
Warranty Information............................................................................5

Instruction Manual
1
Product Overview
Front View
Rear View
LED Indicators
LED Function
Power (1) Solid Green - power is on and normal
Uplink (1)
Solid Green – Connected at 1000Mbps
Solid Yellow – Connected at 100Mbps
Flashing Green - Ethernet Uplink activity at 1000Mbps
Flashing Yellow - Ethernet Uplink activity at 100Mbps
Flashing Yellow - Ethernet Uplink activity at 10M.
LAN (4)
Solid Green – Connected at 1000Mbps
Solid Yellow – Connected at 100Mbps
Flashing Green - Ethernet activity at 1000Mbps
Flashing Yellow - Ethernet activity at 100Mbps
Flashing Yellow - Ethernet activity at 10Mbps
PoE (4) Solid Green - Power over Ethernet function is enabled
OFF - PoE function is disabled, behaving as a regular LAN port
RJ45
RJ45DC Input

Instruction Manual
2
Introduction
The IES51000POE 5-Port Gigabit PoE Switch with 4 PSE ports lets you connect Gigabit
Ethernet and power to four PoE-enabled devices, or a mixture of PoE and
non-PoE components.
Packaging Contents
• 1 x Gigabit Ethernet PoE Switch
• 4 x Mounting Screws
• 1 x Set, Rubber Feet
• 1 x Universal Power Adapter
• 3 x Power Cords (NA /UK /EU)
• 1 x Instruction Manual

Instruction Manual
3
Installation
Wall-Mounting
The Network Switch is designed to sit on a at surface (such as a desktop) or mount to
a wall or similar surface. Skip to the Hardware Installation section below if you are not
wall-mounting the device.
1. Determine the desired location and orientation of the switch on the wall, and mark
both mounting notch location on one side of the integrated mounting bracket,
ensuring they are level.
2. Depending on the mounting surface, use the appropriate tools to install the
included screws into the wall, leaving a gap of approximately 2 mm between the
head of the screw and the wall surface.
3. Place switch back onto the wall with the mounting notches against the previously
installed screws and mark the location for the mounting notches on the opposite
side of the device.
4. With the switch in place on the wall, install the remaining two screws on the other
side so the device is held in place.
Hardware Installation
1. Plug one end of the power adapter into an open electrical outlet and plug the other
end into the DC connector on the side panel of the Network Switch. The Power LED
on the front of the Switch should now be lit.
2. Connect a network cable to the Uplink port on the front panel of the switch, and
connect the other end of the cable into the RJ-45 port on your upstream switch or
router. The Uplink connection speed should auto-detect and the appropriate LEDs
will illuminate to show activity.
3. Connect your PoE or non-PoE devices to the remaining 4 ports on the rear panel
of the switch (e.g. computer, IP Phone, IP Camera, etc.). The switch will auto-detect
connection speed and whether PoE is required, and the appropriate LEDs will
illuminate and show activity.

Instruction Manual
4
Specications
Number of Ports 5 (4 POE)
Compatible Networks 10/100/1000 Mbps
Industry Standards
IEEE 802.3af Power Over Ethernet, IEEE
802.3 10BASE-T, IEEE 802.3u 100BASE-TX/
FX, IEEE 802.3ab 1000BASE-TX, IEEE 802.3x
PoE Output 48V DC, 15.4W (per-port)
Connectors 5 x RJ-45 Female
Maximum Data Transfer Rate 2 Gbps (Full-Duplex)
Switching Architecture Store-and-Forward
Buer Size 512 KB
Full Duples Yes
Auto MDIX Yes
Flow Control Half-duplex back-pressure and IEEE802.3x
full-duplex
Power Consumption 62W Max
Power Adapter 48V DC, 1.35A
Enclosure Material Steel
Operating Temperature 0°C to 50°C (32°F to 122°F)
Storage Temperature 0°C to 50°C (32°F to 122°F)
Humidity 10~90% RH (Non-Condensing)
Dimensions 130 x 90 x 28 mm
Weight 366g

Instruction Manual
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.

Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.