StarTech.com IES61002POE User manual

Manual Revision: 11/13/2013
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
IES61002POE
6 Port Unmanaged Gigabit Ethernet Switch
with 4 PoE+ Ports - 30W per port
*actual product may vary from photos

Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.

Instruction Manual
i
Table of Contents
Product Diagram ....................................................................................1
Introduction............................................................................................2
Packaging Contents ................................................................................................................................. 2
System Requirements.............................................................................................................................. 2
Terminal Block Power Connector.........................................................3
DIP Switch Conguration......................................................................3
LED Indicators.........................................................................................4
Installation ..............................................................................................4
DIN Rail / Wall Bracket Installation...................................................................................................... 4
Specications..........................................................................................5
Technical Support ..................................................................................6
Warranty Information............................................................................6

Instruction Manual
1
Product Diagram
Terminal
Block
Shielded RJ45
LAN Ports
DIP Switch
Shielded RJ45
LAN Ports
with PoE

Instruction Manual
2
Introduction
Packaging Contents
• 1 x 6 Port Gigabit Switch
• 1 x Terminal Block
• 1 x Wall Mount Bracket w/ Screws
• 1 x DIN Rail Bracket w/ Screws
• 1 x Instruction Manual
System Requirements
• RJ45 terminated Cat5 or higher Ethernet cabling
• 10/100/1000 Mbps compatible Ethernet network
• 20-57 VDC Power Supply

Instruction Manual
3
Terminal Block Power Connector
Power can be provided through the dual inputs from separate sources, if needed. One
electrical relay can be wired into an alarm circuit. The relay is connected as Normally
Closed (will open upon alarm condition).
DIP Switch Conguration
1. Alarm Enable: When ‘On’ this switch will disable alarm relay and fault LED if there is
a power failure in one supply. If only connecting to a single power source, place this
switch ‘On’ to disable alarm.
2. BSP: When‘On’ this switch will disable the broadcast storm protection feature which
is enabled by default.

Instruction Manual
4
LED Indicators
PWR1: This green LED will light if power is connected and active at the PWR1 terminal
connection.
PWR2: This green LED will light if power is connected and active at the PWR2 terminal
connection.
Fault: This amber LED will light if one of the power inputs has fault condition and as
long as DIP sw#1 is OFF.
100/1000: This dual color LED will light with amber color when the LAN connected
speed is 1000M, it will light with green color when the LAN speed is 100M and will
remain o if the connected speed is 10M.
LINK/ACT: This green LED will light when the LAN port has a link and will ash when
there is Ethernet trac.
PoE: These green LEDs will light when the LAN has successfully negotiated PoE and is
supplying output power to the remote connected PD device.
Installation
DIN Rail / Wall Bracket Installation
If you are mounting the IES61002POE product onto either a DIN Rail or to a wall, you
will rst need to attach the appropriate bracket(s) to the device as shown below.

Instruction Manual
5
Specications
Number of Ports 6 (4 PoE)
Supported Standards IEEE 802.3at, 802.3af, 802.3, 802.3u, 802.3ab,
802.3z, 802.3x
Connectors 6 x RJ45 Female (Shielded)
1 x 6-wire Terminal Block
LED Indicator(s) PWR1, PWR2, Fault, 100/1000, Link/Act, PoE
Maximum Data Transfer Rate 2 Gbps (Full-Duplex)
Compatible Networks 10/100/1000 Mbps
Auto MDIX Yes
Full Duplex Support Yes
Switching Architecture Store-and-Forward
Maximum Cable Length 330ft (100m)
Power Source Redundant 20 - 57VDC
Power Consumption 2.91A@48VDC, 139.6Watts (120W for PoE)
5.95A@24VDC, 142.9Watts (120W for PoE)
Enclosure Material Metal (IP30)
Operating Temperature 0°C to 60°C (32°F to 140°F)
Storage Temperature -40°C to 75°C (-40°F to 167°F)
Humidity 5~95% (Non-condensing)
Dimensions 135 x 106 x 62.5 mm
Weight 840 g

Instruction Manual
6
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.

Instruction Manual
7