Steelcase 98665-1 User manual

LINE
1
LINE
2
LINE
3
AMP
L2
N
G
L1
L3
AMP
L2
N
G
L1
L3
AMP
L2
N
G
L1
L3
MODEL NO. DESCRIPTION HOT WIRE CODE COLOR
98665-1 LINE 1 DUPLEX “L-1” (APPLICATION CIRCUIT) RED WIRE
98665-2 LINE 2 DUPLEX “L-2” (LIGHTING CIRCUIT) BLACK WIRE
98665-3 LINE 3 DUPLEX “L-3” (E.I.P CIRCUIT) BLUE WIRE
4 OR 5 WIRE
4 OR 5 WIRE
5-WIRE
POWERWAY SYSTEM
WIRING INFORMATION
Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-800-227-2960
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501147 -
Page 1 of 4
Installation For 4 & 5 Wire Duplex Receptacle Into:
Series 9000®Structural Panel
2” P-Series Mobiles Power Panel
Series 9000®Energy Management Worksurface
All electrical installations should be done by a
qualified person in accordance with codes and
regulations applicable at the installation site.
NO CONTACT NO CONTACT NO CONTACT

LINE
1
LINE
1
Assembly Directions
93-9501147 REV - Page 2 of 4
Panel Base Receptacle Installation
Remove trim by pushing down on steel tabs at the bottom extreme
ends (in area of glides) and lifting straight up and out.
1.
APPLY PRESSURE TO STEEL TABS
BASE TRIM
Position duplex receptacle to panel powerway assembly.
Secure receptacle with (2) screws
2.
STRUCTURAL PANEL
POWERWAY
SCREWS
DUPLEX
RECEPTACLE
Remove access cover from base trim.3.
ACCESS
COVER
BASE
TRIM
Replace trim by reversing removal procedure.
NOTE: If receptacle and base trim do not align, the
powerway may be adjusted by loosening the (2)
powerway mounting screws and sliding the power-
way to either end. Re-tighten screws and replace
base trim.
4.
DUPLEX
RECEPTACLE
BASE
TRIM

LINE
1
LINE
1
LINE
1
LINE
1
2” P-Series Mobiles Power Panel (Base Receptacle)
Assembly Directions
93-9501147 REV - Page 3 of 4
Remove trim by pushing down on steel tabs at the bottom extreme
ends (in area of glides) and lifting straight up and out.
1.
Position duplex receptacle to panel powerway assembly.
Secure receptacle with (2) screws
2.
Remove access cover from base trim.3. Replace trim by reversing removal procedure.
NOTE: If receptacle and base trim do not align, the
powerway may be adjusted by loosening the (2)
powerway mounting screws and sliding the power-
way to either end. Re-tighten screws and replace
base trim.
4.
BASE
TRIM
PANEL
ASSEMBLY
LINE
1
SCREWS
DUPLEX
RECEPTACLE
ACCESS
COVER
BASE
TRIM DUPLEX
RECEPTACLE BASE
TRIM

Assembly Directions
93-9501147 REV - Page 4 of 4
Series 9000 Energy Management Worksurface
Open worksurface channel cover and push receptacle onto powerway connector (at right end of powerway). Secure
with (2) screws and close worksurface channel cover.
POWERWAY
DUPLEX
RECEPTACLE
WORKSURFACE
CHANNEL
COVER