Steelcraft AX633-TS Series User manual

TERRAIN
3 WHEEL TRAVEL SYSTEM STROLLER
www.britax.com.au
Series AX633-TS
Suitable for use with the Safe n Sound Unity Baby Capsule
(Baby Capsule sold separately)
IMPORTANT: KEEP THIS BOOKLET IN A SAFE PLACE FOR FUTURE REFERENCE.

02
ALWAYS FOLLOW THE MANUFACTURERS INSTRUCTIONS.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE
OF THIS STROLLER.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS
ESSENTIAL.
• USE GREAT CARE WHEN USING THE STROLLER ON STAIRS,
ESCALATORS, TRAVELATORS OR OTHER MOVING SURFACES.
• IT IS RECOMMENDED TO REMOVE THE CHILD FROM THE STROLLER
BEFORE GOING UP OR DOWN STAIRS OR ESCALATORS.
• DO NOT LIFT THE STROLLER BY THE ARM BAR BECAUSE IT MAY
DISENGAGE.
• DO NOT ALLOW CHILDREN TO STAND ON THE SEAT.
• DO NOT HANG BAGS OR GOODS FROM THE HANDLE AS THIS
COULD CAUSE THE STROLLER TO TIP OVER.
• DO NOT LEAVE THE STROLLER AND ITS ACCESSORIES NEAR AN
OPEN FIRE OR EXPOSED FLAME.
• DO NOT PLACE MORE THAN 4KG IN THE BASKET, OR 1KG IN THE
CANOPY POCKET (IF SUPPLIED).
IMPORTANT NOTES:
IMPORTANT NOTES

03
WARNINGS: TO AVOID INJURY OR DEATH:
ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS
STATIONARY.
• DO NOT LEAVE CHILDREN UNATTENDED.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU
ADJUST THE STROLLER.
• DO NOT USE ANY ACCESSORIES OTHER THAN THOSE APPROVED
FOR USE WITH THIS STROLLER BY BRITAX.
• IT IS UNSAFE TO USE ACCESSORIES NOT APPROVED FOR USE WITH
THIS STROLLER.
• THE MAXIMUM WEIGHT OF THE CHILD USING THIS STROLLER IS
NOT TO EXCEED 17 KG.
This CAUTION Symbol is shown at certain steps in
this Instruction Manual to highlight the danger
of being injured by moving parts.
CAUTION
FOR IMPORTANT NOTES AND WARNINGS ON ACCESSORIES -
REFER TO THEIR INDIVIDUAL SECTIONS IN THIS BOOK.
THE MAXIMUM WEIGHT VARIES FOR EACH ACCESSORY.
WARNINGS

04
The SMART lifting technique
This technique can be used to pick up small light loads from low levels.
Size up the Load
• Assess the load (size, shape and weight).
• Assess whether the load needs to be moved;
• Where is it going to be placed” Check that there are no obstructions;
• Assess whether mechanical or human assistance is required.
Move the Load as close to the body as possible
• A load is heavier to lift or carry if it is not close to the body.
• The whole hand should be used to ensure a rm grip.
Always bend your knees
• Maintain balance.
• Keep feet apart and in a comfortable position.
• Minimise lower back bending.
• Bend knees preferable at as large an angle as possible but not at a right
angle - use a semi squat in preference to a full squat.
Raise the load with your legs
• Achieve the lift smoothly and without jerkiness.
• Maintain the normal curvature of the spine to allow the force of the
load to be distributed evenly from the spine to the pelvis.
Turn your feet in the direction that you want to move the load.
• Avoid unnecessary bending, twisting and reaching.
• Change direction by turning your feet and not your back.
• To set the load down, squat down, keep your head up and let your legs
do the work.
Remember to ‘THINK TALL’ chest lifted, shoulders relaxed, chin
tucked in and head level.
MANUAL HANDLING TECHNIQUES

05
A1 x Stroller Frame,
Seats & Basket
B1 x Canopy
C1 x Front Wheel D2 x Rear Wheels
E 1 x Rear Wheel Assembly
PARTS LIST
F 2 x Locking Clip

06
PARTS LIST
G1 x Head Snuggler B1 x Bootcover
C2 x Shoulder Pads
E 1 x Rain Cover

07
IMPORTANT NOTES:
PLEASE REFER TO PAGE 4 FOR SMART LIFTING TECHNIQUES.
• RELEASE THE STORAGE LATCH WITH DUE CARE AND OPEN THE FRAME.
• WHEN OPENING THE STROLLER, BE AWARE OF THE DANGER OF BEING
INJURED BY MOVING PARTS AND LOCKING DEVICES DURING TH
PROCESS. KEEP ALL HANDS AND LIMBS CLEAR OF THESE PARTS.
• THERE IS POTENTIAL FOR FINGERS OR PARTS OF THE BODY TO BE
INJURED WHEN THE STROLLER IS BEING UNFOLDED, DUE CARE
SHOULD BE EXERCISED.
• KEEP CHILDREN CLEAR OF THE STROLLER WHEN UNFOLDING THE
STROLLER.
• OPEN THE STROLLER SLOWLY AND BE CAREFUL WHERE YOU PLACE
YOUR HANDS.
STROLLER ASSEMBLY
OPENING THE STROLLER FRAME

08
STROLLER ASSEMBLY
OPENING THE STROLLER FRAME
A Lay the stroller frame down at and release the frame lock.
BTo open the frame, lift the handles upwards until the stroller frame
extends and locks into position. Push down on the handle to conrm
the frame is locked.

09
STROLLER ASSEMBLY
INSTALLING THE REAR WHEEL ASSEMBLY
NOTE: Tip the frame over to install the rear wheel assembly.
ATo attach the rear wheels, push in the wheel lock button and then
push the rear wheel onto the axle of the assembly and release the
wheel lock button. Pull on the wheel to ensure it is locked on.
Wheel
Lock
Button

STROLLER ASSEMBLY
10
INSTALLING THE REAR WHEEL ASSEMBLY
BLower the rear wheel assembly onto the rear legs of the stroller frame
and insert the two plastic locking clips into rear legs of the stroller
frame. Pull on the rear wheel assembly to ensure it is correctly
installed.
Plastic
Locking
Clips
CAUTION

11
STROLLER ASSEMBLY
INSTALLING THE FRONT WHEEL
ARemove the plastic protector (where tted) from the front forks. Push
the front wheel axle fully into the wheel forks.
BPlace the securing washer on both sides, ensure the tabs in the
washers are located into the circular holes just above stroller frame.

12
STROLLER ASSEMBLY
INSTALLING THE FRONT WHEEL
CTighten the front wheel axle by turning the quick release hub in a
clockwise rotation and push the lever in to lock.

13
STROLLER OPERATION
USING THE FRONT SWIVEL WHEEL
WARNING: THIS PRODUCT IS NOT INTENDED FOR
JOGGING. DO NOT RUN WHILE USING THIS PRODUCT.
ATo allow the front wheel to swivel for greater mobility, rotate the knob
clockwise until the rivet in the knob faces forward.
BTo lock the swivel wheel, rotate the knob clockwise half a turn and
move the fork until it locks into position.
Note: Pneumatic front and rear tyres can be inated with a bicycle
pump at a garage pump and they have a maximum ination pressure
of 2.4 bar(35 p.s.i).
RIVET

14
STROLLER OPERATION
USING THE BRAKES
WARNING: ALWAYS APPLY THE BRAKES WHEN THE
STROLLER IS STATIONARY.
ATo lock the brakes, push down on the brake lever using your foot.
BTo release the brakes, lift the brake lever using your foot.
A
B

15
STROLLER OPERATION
ADJUSTING THE LEG SUPPORT
ATo adjust the leg support, simultaneously press the buttons in
located on either side of the leg support and lower or raise to the
desired position.
IMPORTANT NOTES:
• THE LEG SUPPORT FEATURE IS PROVIDED FOR YOUR CHILD'S
COMFORT.
• THE LEG SUPPORT IS NOT DESIGNED TO SUPPORT EXTRA WEIGHT.
• DO NOT ALLOW CHILDREN TO STAND OR SIT ON THE LEG SUPPORT.
IT WILL DISENGAGE IF EXTRA WEIGHT IS APPLIED.
• IF LEG SUPPORT DISENGAGES SIMPLY LIFT UP AGAIN TO RESET LEG
SUPPORT.
Note: The leg support should be raised to the highest position when
transporting a baby. This will reduce the risk of the baby falling out
through the front of the stroller. It will not lock in this position.

16
STROLLER OPERATION
ADJUSTING THE BACKREST
WARNINGS:
• THE UPRIGHT POSITIONS ARE NOT SUITABLE FOR USE WITH
CHILDREN LESS THAN 6 MONTHS OLD.
• THE LOWEST RECLINE POSITION SHOULD BE USED TO
TRANSPORT BABIES. THE BACKREST CAN BE ADJUSTED TO A
MORE UPRIGHT POSITION AS THE CHILD GROWS OLDER AND
IS ABLE TO SUPPORT ITS HEAD WITHOUT ASSISTANCE.
Note: If the child is sitting in the seat, support the backrest as it
reclines. If you have diculty adjusting the backrest you may
need to remove the child from the seat to allow you to raise or
lower the backrest with ease.
ATo lower the backrest, lock the brakes (Refer to Section 5). Squeeze
the adjusting bar up on the backrest and lower the backrest to the
desired position.
CAUTION

17
STROLLER OPERATION
ADJUSTING THE BACKREST
BTo raise the backrest, lock the brakes (Refer to Section 5). Hold the
fabric on either side of the seat clear and lift the backrest up until it
locks into the desired position.

18
STROLLER OPERATION
ATTACHING AND USING THE CANOPY
The sun is very strong. DO NOT LEAVE YOUR CHILD EXPOSED TO THE
SUN. The canopy or hood on this product will not give your child total
protection from the harmful rays of the sun.
IMPORTANT NOTE:
A1 To attach the canopy, push the hook strips (1) through the button
holes in the side panels (2) then attach the hook strips to the loop
strips on the side panels (3) now push the canopy mouldings into the
frame mouldings on each side of the stroller until they connect
together.
1 2 3

19
STROLLER OPERATION
ATTACHING AND USING THE CANOPY
A2 Attach the hook strips on the canopy to the pile strips on the
stroller for a secure t.
B1 To open the canopy, pull the canopy forward or to close the canopy,
push the canopy backwards

20
STROLLER OPERATION
ATTACHING AND USING THE CANOPY
B1 For extra protection from the sun, pull the sun visor out from,under
the front of the canopy.