STMicroelectronics STM32F756G-EVAL User manual

Copyright © 2015 ARM Ltd. All rights reserved.
Quick Start Guide
STMicroelectronics STM32F756G-EVAL Board
Install Keil MDK Version 5 –www.keil.com/mdk5/install
Download and install MDK Core and add these Software Packs:
Keil::STM32F7xx_DFP –STMicroelectronics STM32F7 Series Device Support
Verify the installation using example projects provided in the Software Packs:
Connect a 5V/2A power supply to the Power receptacle.
Do not connect the board to the PC! Go to C:\Keil_v5\ARM\STLink\USBDriver and double-
click stlink_winusb_install.bat. The USB drivers for the on-board ST-Link/V2 will install.
Connect the board’s Debug & Power port to your computer using a Mini USB cable.
Windows will now recognize the ST-Link/V2 device and install the drivers automatically.
More Information
Getting Started User’s Guide www.keil.com/gsg
ARM Cortex-M7 Support www.keil.com/mdk5/cortex-m7
Related Products
MDK Version 5: www.keil.com/mdk5
MDK-Professional Middleware: www.keil.com/mdk5/middleware

Copyright © 2015 ARM Ltd. All rights reserved.
Debug and Trace Configuration
STMicroelectronics STM32F756G-EVAL Board
ST-Link Debugger
Trace with ULINKpro
For full trace capability, connect a ULINKpro to the board’s Trace connector and choose ULINK
Pro Cortex Debugger. Configure ETM trace for instruction tracing:
Note: You need to lower the core clock as trace is not supported for clock frequencies above 180
MHz on this microcontroller device.
More Information
Getting Started User’s Guide www.keil.com/gsg
Connect using Serial Wire
Debug (SWD) by
selecting the Port SW.
Configure ITM Trace by
selecting the Trace tab
and enter the correct
CPU Core Clock speed
as specified in your
project. Check the Trace
Enable box.