STODDART SPPL.HSD.HS.001 User manual

Rev: A - 01/02/2018
SPPL.HSD.HS.001
(Wall Mounted)
SPPL.HSD.HS.002
(Stand Mounted)
Model:
Installation Manual
Multi Purpose Liquid / Hand Sanitiser - Dispenser
High Security
This is a multi-purpose secure liquid dispensing system suitable for a variety of liquids for personal use e.g. Hand
Sanitiser, Hand Wash or Sun Screen.
It is the responsibility of the responsible person at the facility where these dispensers are being used to establish
a system to control the contents and manage the risk of use including appropriate labelling in accordance with
Australian/NZ Standards.
Do not leave the refillable bottle separate from its locked enclosure and only remove for refilling. When refilling,
rinse out old contents completely then refill following the instructions of the liquid manufacturer. Note that residue
from oil based liquids will be difficult to completely remove. Do not mix contents from different sources. Thoroughly
clean the bottle and pump if changing the liquid source and/or content e.g. Hand Sanitiser to Sunscreen. The
responsible person for the facility must maintain a system to retain details of contents including ingredients, the
manufacturer and their use, care, first aid and storage instructions.

Due to continuous product research and development,
the information contained herein is subject to change without notice.
Page 1 www.stoddart.com.au
Hand Sanitiser Dispenser - High Security
SPPL.HSD.HS.001 / SPPL.HSD.HS.002
In the box
Tools Required
Assembly - Mounting to Stand (SPPL.HSS.01)
SPPL.HSD.HS.002
SPPL.HSD.HS.001
Assembly - Wall Mounting
1 x Stainless Steel Dispenser Mounting Bracket
1 x Stainless Steel Dispenser Bottle
1 x Stainless Steel Dispenser tray (SPPL.HSD.HS.002 only)
2 x Dispenser Bottle Labels
1 x Pump Mechanism*
1 x Dispenser Cover
1 x Locking Bar
1 x Padlock and Key
4 x M5 16mm Mushroom Phillips Head Screw
4 x M5 Flat Washer
4 x M5 Nylock Nut
Phillips Head Screwdriver #2
Socket Set and/or Shifter Spanner
• Remove the pan supplied with the stand
• Using a Phillips head screwdriver and shifting spanner, secure
the dispenser mounting bracket to the stand with the supplied
M5 mushroom head screws, M5 washers and M5 nylock nuts
• Slide the dispenser tray onto the stand, aligning the notch in the
tray with the mounting bracket leg
• For wall mounting, position the dispenser mounting bracket on
the wall and mark hole positions (it is recommended that the
dispenser unit be mounted no higher than 1200mm from the
ground)
• Drill marked locations
• Secure dispenser mounting bracket to wall using screws and
appropriate wall fixings (screws and wall fixings not supplied)
• Fill the dispenser bottle with hand sanitiser, hand wash or
sunscreen. (refer to manufacturers guidelines on correct use)
• Screw the pump mechanism to the bottle
• Adhere the appropriate dispenser label (describing what
chemical is being used) to the forward facing surface of the
dispenser
1.
3.2.
*Note: Pump mechanism not covered by warranty.
Replacement pumps can be sourced by:
Calling 1300 79 1954
Emailing [email protected]

Due to continuous product research and development,
the information contained herein is subject to change without notice.
Page 2
www.stoddart.com.au
Hand Sanitiser Dispenser - High Security
5.4.
7.6.
• Locate the dispenser bottle over the mounting screw and
anchor leg
• Secure the dispenser bottle to the stand by sliding the locking
bar through the dispenser leg and mounting bracket
• Lock with padlock and key
• Secure the dispenser cover to the stand by sliding the locking
bar through the dispenser cover, dispenser leg and mounting
bracket
• Lock with padlock and key
• Adhere the appropriate dispenser label (describing what
chemical is being used) to the front of the dispenser case door
• To prevent after hours use, remove the padlock and securing
bar
• Slide the dispenser cover over the mounting bracket
• Lift the cover up and push back, then pull the cover down over
the top lip of the mounting bracket

www.stoddart.com.au
International
Sales
Tel: [phone]
Email: [email protected]
Service / Spare Parts
Tel: [phone]
Email: [email protected]
Email: [email protected]
www.stoddart.co.nz
New Zealand Business Number: 6837694
New Zealand
Sales
Tel: [phone]
Email: [email protected]
Service / Spare Parts
Tel: [phone]
Email: [email protected]
Email: [email protected]
www.stoddart.com.au
Australian Business Number: 16009690251
Australia
Sales
Tel: [phone]
Email: [email protected]
Service / Spare Parts
Tel: [phone]
Email: [email protected]
Email: [email protected]