Strong MDI Monarch User manual
1 877 755-3795
sales@strongmdi.com
www.strongmdi.com
MONARCH
INSTALLATION MANUAL
IMPORTANT
Unpack carefully and verify that all parts
are included in the package. Manipulate frame
and screen with care to avoid any damage.
4- Frame sections (2 - sides with
inserts* and 2 - top and bottom)
8- 1/4-20 X1/2" machine screws
2- Wall brackets
1- PVC screen (in a tube)
Legs (optional):
2- Part A.
2- Part B.
8- 1/4-20 X 1/2"
machine screws
If the box contains two Monarch
structures: each structure is identified with
a color dot, one red and the other green.
REAR VIEW / FIGURE 1
READ ALL INSTRUCTIONS BEFORE PROCEEDING
PARTS CHECKLIST:
*Note that the corner
inserts and the wall
bracket mounts are
pre-assembled.
A S S E M B LY
1- Place the four frame sections as indicated in
fig.1. on a flat clean surface, taking care not to
damage the frame finish.
2- Assemble the four sides by inserting the
corners on the top and bottom parts.
3- Assemble each part with the 1/4-20 screws
supplied. Apply gentle pressure on the corners
while tightening the screws for a nicer joint
fi n i s h .
4- Verify the finished frame and adjust if
necessary.
5- Place the screen on the frame; align the
red dot on the screen with the one on the
frame. Handle screen by the edges only, avoid
touching screen surface.
6- Attach the screen to the frame with the
snaps and adjust if required. Snaps are pre-
adjusted but may require minor adjustments.
Red dots Corner insert
1 877 755-3795
sales@strongmdi.com
www.strongmdi.com
WALL-MOUNT INSTRUCTIONS
Install wall brackets ; refer to fig. 2 for the
distance required between the wall brackets.
Install the frame onto the brackets
Screw the wall brackets onto the bottom of the
frame with the supplied screws. (refer to fig. 3)
OPTIONAL LEG SUPPORT SYSTEM
1- Assemble parts A and B for each
leg with 1/4-20 screws.
2- Insert the screen frame (refer to fig. 4).
Be sure that the 2 leg brackets are properly
inserted.
3- Fix angles to the legs with 1/4-20 screws.
WALL BRACKETS / FIGURE 2
WALL MOUNT INSTALLATION / FIGURE 3
LEG SUPPORT INSTALLATION / FIGURE 4
X = Frame width – 1 ¼"
X
A
B
Leg
connection
Angle
connection
