StrongLite Portable Massage Table Package Olympia User manual

Portable Massage Table
Set-up Guide

Opening Your Table
Prop your table upright
onto the rubber feet and
unlock both latches.
Open the table until you
feel a slight resistence
coming from the cables.
Make sure that none of the cables are
tangled around the legs, this will
prevent the table from opening
completely.
Open all four legs of the table to full
extension. Straighten the table as
much as possible.
Congratulations on your portable massage table purchase. This setup guide will assist you in each step of
the setup process.
1 2 3
Standing The Table Up
While the table is on its side,
grab both handles, and place
one foot in front of the edge of
a bottom leg in order to
prevent the table from sliding
or folding.
Pull the table toward you while
keeping the leg in position with
your foot. Once the table is
tilting upward, you can release
your foot from the leg.
Once the table is standing,
ensure that the table top is flat
and the legs are fully extended.
If the table wont go flat, double
check underneath the table to
make sure the cables are free and
clear from entaglement.
3
1 2
*Stronglite portable massage tables are designed to be flat when cables are completely taut.
Due to this, you may notice a slight peak in the table top before your client rests fully on the table.

Height Adjustment
Lean the table on its side and adjust the legs to a
desirable height with the following steps. Ensure all
the legs are adjusted to the same level. When one
side is adjusted, flip the table over and conduct the
same steps on the remaining legs.
The height on your massage table can be adjusted by
approximately 10” in additional height; this will
depend on which model of table you purchased.
1Loosen the rubber knobs by
turning it counter clockwise, and
separate it from the leg and frame.
2Place the leg at
the new desired
height location
and back over
the metal thread.
3Return the rubber knobs and
tighten onto the metal thread.
Facepillow & Platform
The following steps will guide you through mounting the headrest to your table.
Remove the platform and
facepillow from the elastic
straps under the table bed.
Release the handle and extend
the dowels outward. Lock the
handle after the platform is set
to the desired level.
12 3 Insert the dowels into the
wooden table outlet, and
place the facepillow cushion
onto the platform.
Approx.
10”
Dowels Platform
Handle

Portable Table Warranty
Care & Maintenance
990 Joshua Way
Vista, CA 92081
[phone]
[phone]
[phone] fx
[email protected]
Hours of operation:
Monday - Friday
8:00 a.m. to 5 p.m. PST
Saturday - Sunday
Closed
Visit us: Stronglite.com
Like us on Facebook:
facebook.com/stronglite
1-400-0049, rev_030618
Vinyl Care
Keep your table out of extreme cold or heat as this may damage the vinyl. Do not store table in a
vehicle, as that could expose it to intense temperature variations. For best results, transport and store
table in a carry case to protect and preserve the vinyl.
Cleaning & Disinfecting
Remove day-to-day dirt and smudges with mild soap and warm water solution. For tough stains and
to disinfect, use a (100 to 1) water to bleach solution. Spray a damp cloth with the solution to clean.
After each cleaning, gently wipe the vinyl with a damp cloth and clean water, then allow vinyl to air dry
before using or storing.
For more difficult stains, please contact Stronglite for guidance. Do NOT use Armor All® or
citrus-based cleansers. For best results, use only the products suggested above.Alternative cleansing
methods may cause serious damage to your table. Such damage would not be covered under our
warranty program.
We guarantee our portable tables for five (5) years against defects in frame material and
workmanship, and one (1) year against defects in foam and vinyl, from the original date of purchase.
This warranty is valid only for the original purchaser and does not cover damage caused by misuse,
accidents, neglect, or wear and tear, which includes tears in the vinyl and damage caused by
improper storing or cleaning. Customers must provide a proof of purchase to obtain a Return
Material Authorization (RMA) for all warranty claims. This warranty is limited to product repair or
replacement at Stronglite’s sole discretion. Customers are responsible for return shipping, and
customers outside of the contiguous U.S. are responsible for all shipping charges (inbound and
outbound) as well as any applicable duties and taxes.