StudioDesk PRO LINE S User manual

ASSEMBLY MANUAL
PRO LINE S and SL
NOTE: In order to avoid injury or damages,
please do not try to assemble your desk alone.
PRO - Line is a heavy desk, which requires
at least two people to carry out assembly.
Please assemble on soft surface to avoid
scratches to the lacquer.
!
www.studiodesk.net
Check our Step by step video assembly manuals on our
Youtube chanel https://www.youtube.com/c/StudioDesk
Links can be found in User manual section on our website.

The Desk You Deserve
Thank you for making StudioDesk your desk of choice!
Before beginning assembly of your desk, let’s get familiar with the parts you have received in your package.
Please match the corresponding numbers on this page with the drawings.
1. Main Desk Surface
2. Left and right desk surfaces
3. Strengthening boards
4. Rack top mask
5. Cable management
6. Video monitor’s shelf
7. Outer Legs - (left and right)
8. Inner legs - (left and right)
Hardware
Wooden parts
Tools needed - Phillips screwdriver
2
4
3
785
6
1
LR
LR
L
R
9
1
Metal corner
20 pcs
Desk tips
8 pcs
2
M6 Screw
98 pcs
3
M6 Screws for
Rack rails
4
Wooden Dowels
34 pcs
5
Rack rails 8 U
4 pcs
6
4 pcs
9
Washers M6
7 pcs
8
Cable inlays for
Legs 2 pcs
7
Stickers
to cover
inserts
Black
Cage nuts and
M6 x 16 Screws
16 pcs each
10
11
Strengthening bar 1300 mm
1 pc
Strengthening bar 1462 mm
When SL Version ADD
7 pcs
M6 Screw Washers M6
FE 80

1
Step One
Insert dowels (13) into the holes as
shown in the illustration. Use a
rubber hammer if needed.
3
Step Three
Fix assembled parts together using
metal corners (9) and M6 screws (11)
as shown in the illustration.
8
10
4
Step Four
Place inner leg to assembled section onto the
corresponding holes on the leg. Take special care
to avoid scratching the lacquered surface. Push the
Inner leg down until the dowels seat properly in their
respective holes. Use a rubber hammer, if needed.
Usually it is not necessary.
2
Step Two
Assemble parts together on dowels
as shown in the illustration.
www.studiodesk.net

5
Step Five
Once dowels are in place and boards sit tight to the leg,
use metal corners (9) and M6 screws (11) to fix the
middle section to the leg. Repeat procedure with right
Module. Note! Turn the metal corner’s shorter edge downward
Step Six
7
Step Seven
8
10
Bring two modules closer and connect it with middle parts
one by one starting with bottom. Desk surfaces will stand
freely on metal brackets. Push the side modules closer
until the dowels seat properly in their respective
holes in legs and and desk surfaces are tight to each
other.
6
Screw the desk tips to the legs on both left and right module.
8
Step Eight
9
Step Nine
Fix middle section to the legs using metal corners (9)
and M6 screws (11).
Install metal bar to top shelf using M6 Screws.
10
Step Ten
Install rack rails (14) to the legs using
M6 screws (12). Positions for the
screws are predefined.
Install metal brackets on the both side modules
taking into consideration height of your top shelf.
Do not do that step alone. You’ll need help of another person!