StudioDesk Music Commander User manual

The Desk You Deserve
ASSEMBLY MANUAL
Music Commander Reissue - As of June 2019
Video Commander Reissue - As of June 2019
NOTE: In order to avoid injury or damages,
please do not try to assemble your desk alone.
The Commander is a heavy desk, which requires
at least two people to carry out assembly.
Please assemble on soft surface to avoid
scratches to the lacquer.
!
www.studiodesk.net

The Desk You Deserve
Thank you for making StudioDesk your desk of choice!
Before beginning assembly of your desk, let’s get familiar with the parts you have received in your package.
Please match the corresponding numbers on this page with the drawings.
1. Desk Surface
2. Strengthening board
3. Rack dividers - (left and right)
4. Cable management
5. Top shelf
6. Legs - (left and right)
Hardware
Wooden parts
Tools needed (Not included)
Rubber hammer
Phillips Screwdriver
L
R
6
4
11
3
3
5
2
8
Cage nuts and
M6 Screws
32 pcs each
Wooden Dowels
34 pcs
Rack rails 4 U
4 pcs
7
1
Metal corner
18 pcs
Desk tips
4 pcs
2
M6 Screw
80 pcs
3
5
6
4
9
Cable inlay
2 pcs
FE 60
Washers M6
7 pcs
Strenthening
Profiles 2 pcs
8 screws M6 30???
1300 mm

1
Step One
Insert dowels (12) into the holes as
shown in the illustration. Use a
rubber hammer if needed.
3
Step Three
Fix assembled parts together using
metal brackets (8) and M6 screws (10)
as shown in the illustration.
8
10
4
Step Four
NOTE: Two people are required for the remaining
assembly! Insert dowels to the main board as
per description on the left 1a. Install main board
to the leg as shown on 1b illustration
2
Step Two
Assemble parts together as shown
in the illustration using metal brackets
and M6 screws.
www.studiodesk.net
1a
1b

5
Step Five
Once dowels are in place and boards sit tight to the leg,
Connect main board with the rack dividers as shown on the
Illustration on the right.
6
Step Six
7
Step Seven
8
Step Eight
Fix strenthening board to leg using metal corners (8)
and M6 screws (10)
8
10
Secure main board with the metal brackets (8) and
M6 Screws.
Install strengthening board to the leg as shown on
the illustration. Make sure that the board is turned
under proper angle towards leg. Please use our video
assembly manual for more information.

9
Step Nine
Connect strengthening board and main
Desk board with Metal strengthening profiles
As shown on the illustration right.
10
Step Ten
NOTE! Two people needed for this step.
Lift the leg on the top of the structure and carefully
align all dowels with the corresponding holes on the
legs. Be extra careful to avoid scratches on the
lacquered leg.
11
Step Eleven
NOTE! Two people needed for this step.
Install all the metal brackets to fix middle section
with the leg.
12
Step Eleven
Install cable management using M6 screws (3) and
washers (8) as shown on the illustration.