Stuff 4 Multiples TwinTrexx 2 User manual

Twin Baby Carrier
Instructions and Care
TwinTrexx 2®
Twin Baby Carrier
Thank you for choosing a Stuff 4 Multiples product For safety and ease of use, please review all
instructions for use, as well as product care information prior to using carrier In an effort to continuously
improve our products, the actual carrier may vary slightly from the images in the instructions
Care Instructions:
·Hand washing will prolong the life of your TwinTrexx 2® baby carrier
·Do not dry clean
·Do not bleach
·Do not iron
·Air dry only-do not use electric dryer
·Avoid prolonged exposure to sunlight (car, etc) Product fabric may fade
·Avoid prolonged exposure to excessive humidity and/or high temperatures

Features:
·Custom crafted for use as single or twin transportation
·Sleek, modern design for ease of use
·Carefully placed oval arm holes provide comfort for babies of all sizes
·Padded shoulder straps to evenly distribute weight for maximum comfort
·Clicking locks to ensure proper use
·Reinforced seat and leg holes to comfortably support child
·External pockets for convenient storage
Safety Notes:
·This product is for use with children up to approximately 12 months or 25 lbs It is recommended that
all children face inward and ride in the front until they can fully support their own heads
·It is recommended that parent should be comfortable with wearing, adjusting, and removing carrier
prior to carrying children Take frequent breaks from walking whenever necessary
·Always check straps, make fitting adjustments, and confirm that latches are closed and locked in place
prior to placing children in carrier
·Always keep leg openings to smallest possible diameter for use with each child
·Never use carrier as a means of vehicle transportation Always use a car seat
·Never leave children unattended while inside carrier, partially or otherwise If you are loading carrier
from the car, leave children fastened in car seat until each child is ready to be put in the carrier
·Remember to bend at the knees while wearing the carrier with children inside If you are loading
children into a car, remember to bend at the knees while removing them from the carrier-do not bend
forward Also, make sure first child is secured in car seat before removing second baby from carrier
Instructions for use:
Putting on the Carrier-Twin Inward position
1. Pick up one carrier and lift to one side of chest, with the TwinTrexx2 ® logo facing out and the
TwinTrexx 2® logo that is upside down facing your body
2. Place both unfastened arm straps over the same shoulder toward the opposite hip
3. Take the second carrier and bring to the other side of the chest next to the first piece (with logo
side facing out as well) The straps from the second piece will both reach over the opposite
shoulder
4. Take the straps from one carrier and reach them across your back to the opposite side Connect the
buckles at the ends of the straps to the bottom of the other carrier Repeat the process with the
straps on the second carrier
5. Straps should make an ‘X” across the back, each reaching across to the opposite carrier Both
straps from one carrier will cross over the straps from the other (See Figure 1)
Figure 1

6. Connect the two buckles at the front (The buckles in the front will connect leaving one female end
open in the front and one male end buckle unattached closest to your body ) (See Figure 2)
Figure 2
7. At this time, make any adjustments if the carrier is riding too high or too low and tighten straps as
necessary It is recommended that you adjust straps higher than you would initially prefer, as a
shift of weight will lower the carrier a bit and you may need to make slight adjustments after both
babies have been placed into the carrier
8. After your carrier has been adjusted the first time, to remove it you may simply unbuckle the front
buckle as you would a jacket or backpack, and leave it assembled for the next use
Loading the Carrier-Twin Inward Position
1. After putting on the carrier using the instructions above, sit on a soft flat surface (such as a bed-or
a couch with secured car seats near you), and safely place your babies next to you (where they are
not in danger of rolling off)
2. Open the inside child buckle on the side of the carrier you are going to be loading
3. Pick up your baby, and place him/her into the carrier With one hand on the baby, use the other
hand to reach into the leg holes to help guide the baby’s feet
4. Once both legs are through the carrier, make sure the snap on the bottom is adjusted so that each
leg is snug Close the buckle
5. Make any necessary adjustments to be sure that the baby is seated all the way down into the carrier
before repeating the process on the opposite side
6. Open the interior buckle of the second side of the carrier
7. Pick up your baby, and place him/her into the carrier With one arm holding the baby, use the other
hand to help guide the baby’s feet into the leg holes
8. Once both legs are through the carrier, re-adjust the buckle
9. At this time, make any adjustments if the carrier is riding too high or too low and tighten straps as
necessary It is recommended that you adjust straps higher than you would initially prefer, as a
shift of weight will lower the carrier a bit and you may need to make slight adjustments after both
babies have been placed into the carrier
10 After your carrier has been adjusted the first time, to remove it you may simply unbuckle the front
buckle as you would a jacket or backpack, and leave it assembled for the next use

Unloading the Carrier- Twin Inward Position
1. Sit on a flat surface, with a safe place to your set babies down where they are in no danger of
falling
2. Open the inside buckle on one side of the carrier
3. Lift out your baby, and set him in a safe location
4. Repeat on the opposite side
5. Take the carrier off like a jacket by only unlocking the front buckles
6. Neatly fold or hang your carrier on a hanger to prevent straps from twisting and it will be ready to
go for the next use
Loading the Carrier- Twin Outward Position
1 Follow the inward instructions and make sure to fold the front flap and button it so that the upside
down TwinTrexx 2 logo is now facing outward Sit on a soft flat surface (such as a bed-or a couch
with secured car seats near you), and safely place your babies next to you (where they are not in
danger of rolling off)
2 Pick up your baby and place him with his back against your body, between the two straps of the
carrier on the side you wish to load Open buckles With one hand on the baby, use the other hand
to reach into the leg holes to help guide the baby’s feet
3 Once seated, place his arms under the child support straps The straps of the carrier will overlap
the babies
4 Make any necessary adjustments to be sure that the baby is seated all the way down into the carrier
before repeating the process on the opposite side Make sure to close the top buckle
5 Pick up your baby and place him with is back against your body, between the two straps of the
carrier on the side you wish to load With one hand on the baby, use the other hand to reach into
the leg holes to help guide the baby’s feet
6 Once seated, place his arms under the child support straps The straps of the carrier will overlap
the babies Make sure to close the buckle
7 Make any necessary adjustments to be sure that the baby is seated all the way down into the
carrier
8 It is important to remember that a shift of weight will lower the carrier and you may need to make
slight adjustments after both babies have been placed into the carrier Babies should fit as close to
you as possible (See Figure 4)

Figure 4
Unloading the Carrier- Twin Outward Position
1 Sit on a soft flat surface (like a bed) and with a safe place to set babies down where they are in no
danger of rolling off
2 Open the buckle and unbutton the leg portion Lift out your baby with both hands, and set child
down in a safe location
3 Repeat on the opposite side
4 Take the carrier off like a jacket by only unsnapping the front buckles
5 Neatly fold or hang your carrier on a hanger to prevent straps from twisting and it will be ready to
go for the next use
Loading single front carrier-for wearing one front, one back
Tip: The child that will be carried on the back will be lifted on from behind, similar to how one would put
on a backpack Therefore, it is convenient to put the carrier on the rear riding child prior to putting on the
front riding child Once the front child is on, it would be less convenient to have to adjust and put on the
second carrier
1 Place carrier face down in front of you with the straps up (and logo side down) on a flat surface
The upside down logo is facing you
2 Open child strap buckle Place child inside carrier, placing one leg in each leg hole
3 Fasten the snaps around the child’s legs Use the tightest snap position possible (while still
comfortable) for optimal safety Close the buckle
4 Fold down straps, and connect to same side buckle latches (as this rear carrier will be worn like a
backpack)
5 Make sure child is resting in a secure spot (in no danger of falling) until you are ready to put on
the second carrier
For wearing the single carrier in the front position, take the carrier and hold it to your chest To have the
child face outward, make sure the TwinTrexx 2® logo is facing outward while the backwards logo faces
you Close the snap on the front of the carrier so that logo that is inside (backwards) is now facing forward
Toss one carrier strap over each shoulder, and cross them over the back to the opposite side Reach around
and connect the buckle to the buckle latches on the opposite side so that the straps make an ‘x’ across the
back Adjust the straps as necessary to fit snugly and comfortably
1 Place the child inside the carrier, placing one leg in each leg hole Do not release your hold on the
child until he/she is securely seated inside the carrier
2 Fasten the snaps around the leg holes Use the tightest snap position possible (while still
comfortable) for optimal safety Buckle the child strap
3 Sit second child (already wearing carrier) up on couch or in a car seat

4 Bending at the knees with your back to your baby, pull the carrier onto your shoulders as you
would with a standard backpack Straps will not cross on rear carrier
5 Adjust straps as needed for optimal support and comfort
Unloading in the Front-Out & Back-In Twin Position
1 Sit on a soft flat surface (such as a bed), and use one arm to hold the front riding child snugly
Reach down with free hand and unbuckle one side of the front carrier Be careful not to unbuckle
the rear carrier by mistake After one side is unlatched, repeat process on opposite side while
cradling front child with one arm
2 Remove child from carrier and set aside Place child down in a baby seat or other safe place where
they are not in danger of rolling off
3 While sitting on a couch or bed, carefully take hold of the straps of the rear carrier from the top of
your shoulders and gently lower the child to the couch or bed Do not let go of the straps until the
child is safely brought down to the soft surface
4 Remove the child from the carrier and set him/her in a safe place such as a crib, playpen or baby
seat
WARNING:
FOLLOW INSTRUCTIONS FOR USE SMALL CHILDREN CAN FALL THROUGH LEG OPENINGS
ONLY USE THIS CARRIER FOR CHILDREN BETWEEN 7LBS AND 20 LBS
FOLLOW PROPER PLACEMENT GUIDELINES AND INSTRUCTIONS FOR USE PLEASE
EXERCISE CAUTION AT ALL TIMES CHECK TO MAKE SURE ALL BUCKLES, SNAPS, STRAPS,
AND ADJUST- MENTS ARE SECURE BEFORE EACH USE
WEARER MUST BE SURE THAT BABY’S AIRWAY IS CLEAR AND THAT BABY IS BREATHING
NORMALLY AT ALL TIMES BABY SHOULD NOT BE CURLED TIGHT CHIN TO CHEST
BECAUSE THIS PARTIALLY CLOSES BABY’S AIRWAY BABY’S LEGS AND FEET NEED TO BE
OBSERVED WHILE IN THE CARRIER THE LEGS SHOULD COME OUT OF THE OPENINGS ON
THE SIDES OF THE CARRIER AND STRADDLE THE WEARER’S WAIST OR STOMACH BE
SURE TO CHECK THAT THE LEGS AND FEET ARE IN NO WAY CONSTRICT- ED BY THE
CARRIER
NEVER UNBUCKLE THE WAIST BELT WHILE THE BABY IS IN THE CARRIER NEVER WEAR
CARRIER WITH CHEST STRAP UNBUCKLED
ONLY USE THE OUTWARD POSITION WHEN BABY HAS STRONG AND CONSISTENT HEAD
AND NECK CONTROL
YOUR BALANCE MAY BE ADVERSELY AFFECTED BY YOUR MOVEMENT AND THE
MOVEMENT OF YOUR CHILD TAKE CARE WHEN BENDING OR LEANING FORWARD,
SIDEWAYS OR BACKWARD
TO AVOID INJURY WHEN LEARNING TO PLACE YOUR BABY IN THE CARRIER, DO SO OVER
A BED OR OTHER CUSHIONED SURFACE WITH THE HELP OF ANOTHER PERSON
THIS CARRIER SHOULD NOT BE USED BY A PERSON WITH PHYSICAL PROBLEMS THAT
MIGHT INTERFERE WITH THE SAFE USE OF THE PRODUCT, INCLUDING BUT NOT LIMITED
TO: MUSCULAR, CIRCULATORY OR SKELETAL PROBLEMS, PROBLEMS WITH BALANCE OR
DIZZINESS, OR PAINFUL DISORDERS OF THE BACK OR LEGS
THIS CARRIER SHOULD NEVER BE USED IF THE WEARER IS IMPAIRED BY ALCOHOL OR
DRUGS OR IF THE WEARER IS TIRED OR IN PAIN, AS BALANCE AND REFLEXES MAY BE
IMPAIRED

THE CARRIER SHOULD NOT BE USED WHEN JOGGING, CLIMBING, BIKING, OR
PARTICIPATING IN OTHER SPORTING OR STRENUOUS ACTIVITIES
HANDS SHOULD ALWAYS BE AVAILABLE TO CHECK AND ADJUST BABY’S POSITION
INSPECT THE BABY CARRIER REGULARLY FOR ANY SIGNS OF WEAR AND TEAR,
ESPECIALLY AROUND STRAPS, SAFETY ELASTIC LOOPS, BUCKLES AND SEAMS