11 12
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
16. Drawer installation
1a. Extend the ball bearing slide tracks on the unit all
the way forward (including ball bearing cart).
1b. Align the slide runners on the assembled drawers
with the slide tracks and push the drawer carefully
inside until it stops.
NOTE: If the drawer does not go in smoothly, please
take it out and repeat the step. If you need to remove
the drawer, please pull the drawer all the way out, then
simultaneously pushes the plastic release lever of the
ball bearing slides up on one side and down on the other
side, and then pull it completely out.
18. If you buy more than one unit, you can collect more
style.
19. Secure units together by attaching the metal plates
(II) with the 1/4” x 12 mm bolts (AA) into the holes, tighten
with hex wrench (CC).
NOTE: Must install step 17 for all secured units
17. Adjust oor levelers to level the unit against the wall
where desired. Using top frame (B) as a template, mark
one mounting holes location on the wall. Drill one pilot
holes into the wall where previously marked. Make sure
that the drilled holes can t for the wall anchors (sold
separately) properly. Press the anchors into the holes
and gently tap with a hammer until ush in the holes. If
the mounting hole coincides with a wooden stud, there is
no need wall anchor. Align top frame (B) and back cross-
ers (NN) over the drywall anchors (GG) and secure with
M5 x 65 mm screw (OO). Tighten securely with phillips
screwdriver.
16
18
19
17
Hardware Used
BOO
GG NN
AA
II CC
Drywall Anchor x 1
x 1
GG
Back Crosser
x 1
OO
NN
M5 x 65 mm
Screw
1/4” x 12 mm Bolt
Hex Wrench
x 6
x 1
AA
CC
Hardware Used
Metal Plate x 2
II
CARE AND MAINTENANCE
LIMITED LIFETIME WARRANTY
This product is warranted to the original purchaser. If there is a failure in this unit due to defects in
materials or workmanship, the manufacturer will repair or replace this item at our discretion without
charge. Warranty is void if product has been assembled incorrectly, misused, abused by
overloading, altered in any way or damaged due to accident. This warranty is not transferable and
does not cover chipping, aking, scratches, rust, dents, or other damages to the surfaces of this
product. Responsibility of the manufacturer is limited to repair or replacement of this product. The
manufacturer is not responsible for consequential, incidental, or other damages or losses resulting
from product failure.
This warranty is in lieu of all other expressed warranties. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specic legal rights and you may have other rights which vary from state
to state.
• Periodically check to make certain all components are properly positioned, free from damage
and rmly connected.
• Use a soft, clean cloth that will not scratch the surface when dusting.
• Never use water to clean the furniture as it may cause damage to the nish.
• Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
• In the event that the furniture is stained or otherwise damaged during use, it is recommended
you call a professional to repair the furniture.
• Keep furniture away from direct sunlight as it may damage the nish.
• It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
