STYLEX Bounce Installation instructions

safety glasses
hammer
phillips screwdriver
utility knife
2. Position the chair upside down. Use a
Phillips head screw driver to unscrew
the seat from the frame. There should be
four screws in total.
3. Lift the seat off of the frame to reveal
the seat pan. Use a Phillips head to
unscrew the screws attaching the seat
pan to the frame. There should be four
in total.
4. Remove the upholstery from the seat by
simply unzipping it and stripping it from
the frame. First do the outside lining
then do the same with the tensioned
mesh suspension. Feel free to use a
utility knife to make the work easier.
1. The arm rests of the chair are plastic
inserts. To remove them, tap them with
a hammer going in the direction away
from the frame. Do this until they pop
loose.
www.stylexseating.com 800.257.5742 Disassembly Bounce
- Tensioned web suspension
- Material: Elastic mesh
- Phillips round-head (bolts and screws)
-Material: Steel
- Seat
- Material:
Foam, plastic, upholstery
-Arms rests
-Material: Nylon plastic
-Seat pan
-Material: HDPE plastic
x8
C
B
A
D
Tools Required
Disassembly and Recycling Document
Disassembly Time:10min / No Special Training Required
Breakdown Steps
Model: Bounce
*Refer to P.2 for model variations
Foam
-Seat frame
-Material: Steel
-Frame structure
-Material: Steel
P.1

www.stylexseating.com 800.257.5742 Disassembly Bounce
Disassembly and Recycling Document
Disassembly Time:10min / No Special Training Required
Models: Bounce
P.2
Chair Variations
Bounce
The Bounce chair has different versions to fit its uses.
All models are availble with or without arms.
- Fully upholstered seat and back (figure A1).
- Fully upholstered seat and back w/ arms (figure
A2).
- Fully upholstered seat and back with sled frame
(figure A3).
- Fully upholstered seat and back with desk arm
(figure A4).
Disassembly for all of these versions is fairly similar
to the original. Please use P1 as a disassembly
reference for all of these variations.
A2 A3A1
A4