STYLEX Zephyr Installation instructions

safety glasses
mallet
phillips screwdriver
prybar
vice grips
1. Flip the chair upside and use a phillips
screwdriver to unscrew the plastic arm
caps (figure A1). While the chair is up-
side down use the same screw driver to
unscrew the leg glides from the bottom
of the chair legs (figure A2).
3. Position the chair upside down but with
the seat facing you. You will notice
under the support bar, screws holding
the back of the chair to the metal frame.
Use a phillips head screwdriver to
unscrew these screws.
4. Once the back of the seat is removed,
unscrew the rubber buffer from the
back support of the chair (figure D1).
Finally use a hammer to strike the back
panel from the metal frame (figure D2).
2. Keeping the chair upside down you will
notice screws holding both the plastic
buffer and the seat to the metal frame.
Unscrew these screws.
www.stylexseating.com 800.257.5742 Disassembly Zephyr
- Back support
- Material: Cast aluminum
- Phillips round-head screws
- Material: Steel
- Seat and back
- Material:
Nylon, nylon mesh
-Frame structure
-Material: Steel
-Leg glides
-Material: Nylon plastic
x4
- Washers
- Material: Steel
-Arm caps
-Material: ABS, P.C. or acrylic
- Chair buffers
- Material: Polyurethane foam
x3
x16
Tools Required
Disassembly and Recycling Document
Disassembly Time:10min / No Special Training Required
Breakdown Steps
Model: Zephyr
*Refer to P.2 for model variations
C
B
A1
D1
A2
D2
x2
P.1

www.stylexseating.com 800.257.5742 Disassembly Zephyr
Disassembly and Recycling Document
Disassembly Time:10min / No Special Training Required
Models: Zephyr
P.2
Chair Variations
Zephyr
All models are available with or without arms.
- Nylon mesh suspension seat and back
(figure A1).
- Upholstered seat (figure A2).
- Stool (figure A3).
Disassembly for all of these versions is fairly similar
to the original. Please use P1 as a disassembly
reference for all of these variations.
A2 A3A1