Summer SupportMe 3-in-1 User manual

53340z, 53340
CAUTION: KEEP SMALL PARTS OUT OF CHILD'S REACH.
• PREVENT FALLS:
• Never use near stairs. Never use on any elevated surface.
• To avoid tip over, place product on a flat level surface.
• Strings can cause strangulation! DO NOT place items with a string around child's neck, such
as hood strings or pacifier cords. DO NOT suspend strings over product or attach strings to toys.
WARNING:
Never leave child unattended.
Always keep child in view while in product.
• Always secure child using restraint straps until child is able to get in and out of the booster seat
without help (about 2 1/2 years old). The child should be secured in the booster seat at all times
by the restraining system. The tray is not designed to hold the child in the chair.
• Never leave child unattended.
• Do not use in motor vehicles.
• ALWAYS secure BOTH back and seat straps to an adult chair.
• NEVER allow child to push away from table.
• NEVER lift this product with your child in it.
• NEVER use soft seat without main seat.
• Do not use this product if it is damaged or broken.
• ALWAYS remove tray sections for proper fit to an adult chair during booster seat usage.
• Use ONLY for a child that can sit up unassisted.
• NEVER use this product as a car seat or bath seat, on a table or counter top, stool, swivel chair,
or any other chair where the straps cannot secure it properly.
• For use on a chair whose seat dimensions are greater than those of the booster seat.
• Check that both the floor and seat of the chair are level before installing the booster seat.
• Once installed, check the security and position of the booster seat.
• Always check security of fit to adult chair before each use.
• Do not use on a stool, an unstable chair or folding chair.
• Do not use this booster unless all components are correctly fitted and adjusted.
• Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires,
gas fires etc. in the vicinity of the booster seat.
WARNING:
Prevent serious injury or death from sliding out, falls,
or tipping over.
Please read the following instructions and
warnings carefully before use.
Keep this instruction manual
for future reference.
For technical support see page 4.
For use with children from 4 months to 4 years.
Maximum weight 33 lbs. (15 kg.)
Adult Assembly Required.
SupportMe 3-in-1
Positioner & Booster
Stage 3: Booster seat for toddler
Note: All straps must be used during booster seat mode.
Step 1: Locate chair straps taped to the bottom of the seat base.
Step 2: Slide folded ends of chair straps into slots on the back of
the seat (Figure I). Pull up to ensure chair straps are secured in slots
(Figure J). Repeat for slots in the side of seat with the second set of
chair straps.
Note: Depending on size of child, use either small or large support.
Store unused support underneath. Either keep in or remove foam
insert for childs comfort.
Wipe plastic components with warm soapy water and rinse clean. Wipe with a clean dry cloth.
TO CLEAN:
L
SET-UP & USE (continued):
I
J
© 2013 Summer Infant, Inc.
Summer Infant, Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-800-268-6237
Summer Infant Europe, Ltd.
First Floor, North Wing
Focus 31, Cleveland Road
Hemel Hempstead, HP2 7BW UK
[phone]
Colors and styles may vary.
Please retain information for future reference.
Straps and foam insert made in China.
All other components made in USA.
4
Summer Infant stands behind all of its products. If you are not completely satisfied
or have any questions, please contact our Consumer Relations Team at
1-800-268-6237 or www.summerinfant.com/contact.
(For Europe call [phone] or customerser[email protected])
www.summerinfant.com
INSTRUCTION MANUAL

2
COMPONENTS:
QUICK GUIDE:
Stage 1:
infant support seat
(with large support and foam insert)
Use when child can hold up
head unassisted.
Stage 2:
booster seat with tray
(with large support and tray,
with or without foam insert)
Use until child begins to
walk unassisted.
Stage 3:
booster seat for toddler
(with small support
and large support stored )
3
Stage 2:
Booster seat with tray
NOTE: All straps must be used
during booster seat mode.
Step 1: Locate chair straps taped to
the bottom of the seat base.
Step 2: Slide folded ends of chair
straps into slots on the back of the
seat (Figure C). Pull up to ensure chair
straps are secured in slots (Figure D).
Repeat for slots in the side of seat
with the second set of chair straps.
Step 4: Place booster seat onto chair.
Pass the bottom chair straps under
base of chair and secure buckle. Pull
and tighten chair strap to ensure a
snug fit (Figure E).
Step 5: Pass rear chair strap around
back of chair and secure buckle. Pull
and tighten chair strap to ensure a
tight fit (Figure F).
Step 6: Unbuckle child restraint
straps and place child in seat. Buckle
child into child restraint and tighten
straps for a snug and secure fit
(Figure G). Clip tray onto sides of seat.
(Figure H). Note: Depending on size
of child either small or large support.
Store unused support underneath
hole. Either keep in or remove foam
insert for childs comfort.
Chair straps** (2)
* Child restraint straps are
pre-assembled on product.
** Chair straps are taped
to the underside of the seat.
*Colors and styles may vary.
small support large support
Child
restraint
straps*
Removable
Foam Insert
Main
seat
SET-UP & USE:
Stage 1:
Floortime Infant
support seat
(no assembly necessary)
Step 1: Unbuckle child restraint
straps and place child in seat. Buckle
child into child restraint and tighten
straps for a snug and secure fit.
NOTE: For smaller babies use larger
support and foam insert (Figure A).
Store the smaller under the seat. For
larger babies or as they grow, use
small support (Figure B) and store
larger underneath. Depending on size
of child either keep in or remove
foam insert.
A B
CD
E
G H
F