Summer Mill Valley Safety Gate 27960 User manual

Mill Valley Safety Gate™
OWNER’S GUIDE
Please read the following instructions carefully.
Keep this instruction manual and save for future reference.
Tools required (not included): Phillips-head screwdriver and
power drill, 7/32" drill bit may be needed.
For use with children from 6 - 24 months.
Keep small parts away from children.
Adult assembly required.
Fits openings from 29" - 42" wide.
27960
Have questions? We're here to help! For technical support please
contact us at 401-671-6551 or www.summerinfant.com/contact.

components
Children have died or been seriously injured when gates are not securely installed.
• ALWAYS install and use gates as directed using all required parts. Install according to manufacturer’s instructions.
• STOP using when a child can climb over or dislodge the gate.
• Use only with the locking/latching mechanism securely engaged.
•NEVER use a gate to keep child away from pool.
•NEVER leave child unattended.
• ALWAYS close and lock the gate behind you.
• This product will not necessarily prevent all accidents. Proper adult supervision is required at all times.
• Do not use if any components are missing or damaged.
• Adult assembly required. Exercise care when unpacking and assembling product.
IMPORTANT – Read the instructions carefully before use and keep them for future reference.
CAUTION KEEP SMALL PARTS OUT OF CHILD’S REACH.
Gate Door
Precision-Fit Installation Template
A
A
B
E
D
C
HI
G
F
B
Support Foot Assembly
Upper & Lower Hinge Brackets
C
D
Lower Gate Latch
Upper Gate Latch
E
F
Door Stopper
(must be used when installing gate at the top of stairs)
Upper One-Directional Stoppers
(must be used when installing gate at the top of stairs)
G
Baseboard Extension Kit
• Upper Wall Extender
• Lower Hinge Bracket
(optional for upper gate latch)
Upper Wall
Extender
Lower Hinge
Bracket
H
I
Support Foot Fasteners
2˝Long Screws (2)
Wall Anchors (8)
Wrench
J
1˝ Flat Head Screw (5)
M
N
1¼˝ Medium Screws (4)
K
L
O
hardware:
x1
x5
J
K
L
M
N
x8
O
x1
x4
2
WARNING
x2

installing the gate
3
x 1
J
Twist the base onto
the support foot (part C).
Using the
Support Foot Fasteners (parts J),
attach the support
foot to the bottom
of the gate.
2
nd
!
IMPORTANT: This instruction booklet
illustrates Top of Stairs gate installation
(you may also install the gate between
rooms).
For TOP OF STAIRS:
You must install one of the included Upper
One-Directional Stoppers (part G). This
step is covered on page 9.
Make sure to position the gate a minimum of
3-6 inches (8-15cm) away from the top step.
For HALLWAY or DOORWAY
installation, the stoppers are optional.
STEP 1: Assemble the Support Foot
1
st

Remove
Template.
Remove
Template.
installing the gate (continued)
Slide both Hinge Brackets
(parts D) into slots in
Precision-Fit Installation
Template (part B). 1. Slide the Upper Hinge
Bracket (part D) into the
top of the template.
2. Slide the Lower Hinge
Bracket from the Baseboard
Extension Kit (Part I) into the
bottom of the template.
3
rd
x 1
D
D
x 2
D
x 4
N
IMPORTANT: If mounting into
plaster or drywall, use wall
anchors. Using a 7/32" drill bit,
drill a pilot hole into the wall,
then insert wall anchors prior to
mounting hardware.
!
Hold the template
against the wall. Make
sure the bottom of
the template is
touching the floor.
With the template in
place, attach the Upper
and Lower Hinge Brackets
with the screws
provided (parts K).
STEP 2: Attach Upper &
Lower Hinge Brackets
2
nd
1
st
x 1
I
I
x 4
K
4
!
NOTE: If baseboards are present:
IMPORTAN T: At the top of the landing,
position the gate a minimum of 3-6 inches (8-15cm) away from the top step.
!

installing the gate (continued)
5
2
nd
Lower gate door
onto hinges.
Hold gate door
at 90 degrees to wall,
in open position.
STEP 3: Place Gate Door Into Position
1
st

installing the gate (continued)
Tighten the
upper and
lower hinge nuts.
3
rd
4
th
Adjust the
Support Foot so
it gently contacts
the floor when
the gate is closed
and locked.
O
6

2
nd
installing the gate (continued)
Slide the Upper (E) & Lower (F)
Gate Latches onto the Gate.
Extend the Gate fully to the wall.
STEP 4: Attaching the Gate Latches
1
st
Extend the Gate,
stopping just short
of the opposite wall.
7

3
rd
4
th
installing the gate (continued)
Hold the Upper (E) and
Lower (F) Latches in place.
With a pencil, mark the
screw holes in the latches.
x 4
N
Install wall
anchors,
if necessary.
8
x 4
N
IMPORTANT: If mounting into
plaster or drywall, use wall
anchors. Using a 7/32" drill bit,
drill a pilot hole into the wall,
then insert wall anchors prior to
mounting hardware.
!

2
nd
3
rd
installing gate latches & door stoppers
Attach the Upper
One-Directional
Stopper and the
Upper Gate Latch.
Attach the
Lower Gate
Latch.
!
IMPORTANT:
FOR TOP OF STAIRS INSTALLATION:
Two Upper One-Directional Stoppers are included with this gate. Install
the Stopper that prevents the door from opening over the stairs.
Gate should never open over the stairs.
Scenario 1
Hallway/Doorway-
Use Upper and
Lower Gate Latches.
(Door Stoppers optional)
Scenario 1
Hallway/Doorway-
Use Upper and
Lower Gate Latches.
(Door Stoppers optional)
x 2
L
x 2
L
x 2
M
x 2
L
1
st
Retract the Gate
and swing it out
of the way.
Baseboard Kit Installation
9
Scenario 3
Top of Stairs with Baseboard-
Use Baseboard Extension Kit (parts I)
with Upper One-Directional
Stopper and Upper Gate Latch.
Scenario 3
Top of Stairs with Baseboard-
Use Baseboard Extension Kit (parts I)
with Upper One-Directional
Stopper and Upper Gate Latch.
Scenario 2
Top of Stairs-
Use Upper
One-Directional Stopper
with Upper Gate Latch.
Scenario 2
Top of Stairs-
Use Upper
One-Directional Stopper
with Upper Gate Latch.

Mount the Door Stopper (part H)
to the top of the gate, with
the Short Screw (Part K).
2
nd
3
rd
installing the door stopper
1
st
x 1
K
Use the width of the Wrench
provided to determine where to
mount the Door Stopper (Part I)
on the top of the gate door.
Use the width of the Wrench
provided to determine where to
mount the Door Stopper (Part H)
on the top of the gate door.
Close the gate door.
Close the gate door
to the locked position.
!
IMPORTANT: Be sure to
install the door stopper
when using at the top of
stairs!
FINISHED!
10