Summer 2641 Instruction Manual

Baby Zoom / Best View General usage and Pairing guide
(02641)
Further Contact : Tel : [phone] Web : www.summerinfant.co.uk e-mail : [e-mail]

Contents
Page Content Step
1 Monitor Buon funcons -
2 Using the Toggle Switch -
3 Camera Buon Funcons -
4 Adding and Pairing an addional camera 1
5 Adding and Pairing an addional camera 2
6 Adding and Pairing an addional camera 3
7 Adding and Pairing an addional camera 4 + 5
8 Adding and Pairing an addional camera 6
8 Using mulple cameras 7

Power On / Off Pan / Zoom Menu
Video On / Off
Buon funcon Guide
Please familiarise yourself with the buons on your monitor before
aempng to change any sengs.
(Close up image)
1

Using the toggle Switch
To use the toggle switch to pan the camera or whilst navigang the monitors menu, you need
to pull the toggle switch in the direcon you require.
Picture ‘A’ shows pulling the toggle switch
to the down posion using your thumb.
Picture ‘B’ shows pulling the toggle switch
to the down posion using your index
finger.
Please note that you are not required to push in the toggle switch during panning in any
direcon.
2
To zoom in press in the Pan / Zoom toggle buon once. To zoom out,
press it once again :
AB

Camera On / Off
Camera Pairing Buon
(Close up image)
3

Adding and Pairing an addional Camera
Press the Menu Buon on the Monitor once :
Whatever is highlighted in red can be changed.
Note the volume ‘VOL’ is highlighted in red showing that the volume can be adjusted.
4
Step 1
You will then see the screen below :
Turn on the monitor by holding down the (Power On / Off) buon for
2 seconds :

Scroll down using the Pan / Zoom toggle switch :
You will need to pull the toggle switch down three mes unl the
‘ADD / DEL CAM’ is highlighted in red. (Do not push in the central buon)
You will then see the screen below :
5
Step 2

Press in the Pan / Zoom buon once :
You will then see the screen below :
6
Step 3

Press the pairing buon on the rear of the camera :
(The buon is located at the rear of the camera base next of the ariel)
Ensure the camera you are going to pair is switched on :
Step 4
7
You will need to acon ‘step 5’ within 5 seconds of pressing the camera
buon in ‘step 4’ so please read ahead.
Please ensure that the camera and monitor are next to eachother
and no further apart that 1 meter.
Press in the Pan / Zoom Buon on the monitor within 5 seconds
of pressing the camera buon:
If you aempt to acon this step before pressing the camera
pairing buon, the screen may freeze. If this happens wait ten seconds
and start again from step 4.
Aer a few seconds your second camera will be paired and you will
see a screen like this :
Step 5
(Each me a camera is successfully paired it will show in blue on the screen above. The screen
above shows that two cameras are paired because DEL CAM#1 and DEL CAM#2 are highlighted
in blue).

Press the menu buon twice to exit the main menu :
8
Step 6
You can now enjoy panning and zooming on both cameras
If more that one camera is used you need to manually switch between cameras.
You can change which camera you want to view by pressing ‘MENU’ and using the toggle
switch to scroll down to ‘Cam Display’. You will automacally be on camea #1 as shown in
picture A. To view camera #2, use the toggle switch to move to the right as shown in
picture B.
Step 7
A B
Press the ‘MENU’ buon again to exit the menu and start viewing your selected camera.