Sunbeam Slurples SL4600 User manual

Slurples
Slushie Drink Maker
Instruction Booklet
SL4600
Please read these
instructions carefully
and retain for future
reference.

Important instructions – retain for
future use.
Contents
Sunbeam’s Safety Precautions 1
Features of your Sluples slushie drink maker 2
Assembly Instructions 4
Using your Slurples 5
Dispensing your slushie drink 6
Slushie drink suggestions and tips 7
Care and Cleaning 8

1
Sunbeam are very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by young
children or infirm persons unless they have
been adequately supervised by a responsible
adult to ensure that they can use the appliance
safely.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Never leave an appliance unattended while
in use.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR SLURPLES
THE SLUSHIE DRINK MAKER.
• This appliance is not a toy.
• Operate the slushie drink maker on a flat
surface.
• Do not leave your slushie drink maker
unattended.
• Do not place any part of this appliance in a
dishwasher.
• Do not add more than the recommended
amount of salt.
• Do not place ice canister in freezer.

Features of your Slurples slushie
drink maker
Salt dispensing cap
Used for measuring salt and adding salt.
Jug
Dispensing tap
Turn the dispensing tap when your slushie
drink is ready to serve.
Removable drip tray
Catches any drips and is removed for easy
cleaning.
2

Lid
Ice canister
Ice and salt go into the ice canister to make
Slurples super cold, super fast!
Slushie paddles
Power switch
On/Off/Dispense.
3

4
1. Before using your Slurples for the first
time ensure that all packing material is
removed.
2. Wash all parts in warm soapy water, rinse
well and dry.
3. Place the base on a level benchtop. Place
the Slurples jug on top of the motor base
and ensure that it sits firmly in place with
the dispensing tap over the drink tray.
Figure 1.
4. Insert the ice canister to fit inside the
outer slushie paddles. Then insert the inner
ice paddles to fit inside the ice canister.
Figure 2.
5. Clip in the locking latches on the inner ice
paddles into the outer slushie paddles.
Figure 3.
6. Place the canister with assembled inner
and outer paddles into the Slurples jug.
Ensure that the canister sits flush on the
base of the jug.
Assembly Instructions
Figure 1
Figure 2
Figure 3

5
Using your Slurples
1.Turn Slurples to the ‘off’ setting on the
side switch.
2.Plug the unit into a 230 -240 volt AC
power outlet and switch the power on.
3.Secure the lid on to the Slushie jug.
Place the front end on first, then secure
the locking latch onto the rear clip of the
canister. See Figure 4.
4.Turn the side switch to ‘on’. The inner and
outer paddles will start to rotate.
5.Slowly pour the chilled drink mixture into
the rear section of the lid. You will see
the drink mixture through the jug being
churned by the paddles.
Important: Do not place more than 1 litre (to
the MAX line) of drink mixture in Slurples.
6.To fill the inside of the canister, remove the
cap from the lid and add ice cubes through
the lid opening to half fill the canister (this
will take about 8 -10 standard size ice
cubes). When the canister is half full of
ice, turn the cap upside down and fill with
rock salt. Add the rock salt to the ice.
Note: Regular square ice cubes work best in
Slurples.
7.Add another 8 -10 standard size ice cubes
through the lid opening until the ice
reaches the maximum fill indictor disk on
the inside of the canister, then add another
capful of rock salt.
Important: Do not overfill above the
maximum fill indictor disk with ice and rock
salt. See Figure 5.
8.Pour ¼ cup (60ml) of water over the top of
the rock salt and ice.
9.Place the cap back on the lid.
10.Leave the unit running for 10 to 15
minutes, depending on the desired
‘slushie’ consistency.
Note: A warmer room temperature may
increase this time.
11. After 5-7 minutes check the ice and rock
salt mixture through the lid opening. If the
ice has melted, add a few more ice cubes
and ½ capful of rock salt at a time.
Important: Do not fill to the top of the
canister with ice and rock salt.
Figure 4 Figure 5
Maximum fill
indicator disk

6
Dispensing your Slushie drink
1. When peaks form in the slushie mixture,
adjacent to the paddles the mixture has
reached a good consistency.
2. Turn the side switch setting to the
‘Dispense’ setting to serve the slushie
drink. This will reverse the paddle
direction.
3. Place a glass underneath the dispensing
tap and turn to the ‘pour’ position.
4. The slushie mixture will dispense from the
tap into your glass.
5. To turn the dispenser off and to stop the
flow, turn the tap counter clockwise.
6. Set the side switch to ‘on’ to continue
mixing. Or switch to the ‘off’ position when
you have finished using Slurples.

7
• All drinks should be chilled before adding
to Slurples.
• Soft drinks work best in Slurples.
• Use you favourite cordial in Slurples. We
recommend using more than the suggested
concentrate amount when mixing with
water as when cordial freezes, the flavour
is not as concentrated.
• Fruit juice drink drinks can be used in
Slurples. 100% fruit juice is not suitable
as it will freeze the paddles to the canister.
We recommend using fruit juice drinks
which are 35% real fruit juice only.
• Diet soft drinks will not work in Slurples.
• Frozen cocktails can be made using
Slurples but do not add alcohol until
approximately 1-2 minutes before
dispensing.
Slushie drink suggestions

1. Set the side switch to the ‘off’ position and
remove the plug from the power point.
2. Remove lid from the Slurples jug.
3. Remove the ice canister from the jug and
discard any remaining ice and salt.
4. Carefully lift the locking latches from the
ice paddles and disassemble the inner and
out paddles from the canister.
5. Place the ice canister, paddles, lid and
cap in warm soapy water and rinse in cold
water.
Note: The ice canister and paddles must
be seperated before washing to remove any
excess salt. Ensure that no salt is left in
contact with the cannister
6. To clean the Slurples jug rinse under
warm water. Turn the dispensing handle
clockwise to allow water to rinse through
the tap.
Never immerse the Slurples base in water.
7. Wipe the base of Slurples with a warm
cloth to clean.
Important: DO NOT PLACE ANY PART IN
THE DISHWASHER.
8
Care and Cleaning