
5
Warning: When filling the water reservoir, watch for water that can
drip onto the floor and cause you to slip and fall.
Tip: It is not necessary to have a full reservoir of water for the Steamer
to generate steam. For best results, just make sure the water reservoir is
at least half full.
4. Close the water-fill cover and refit the water reservoir into the stand.
Pull on the reservoir to ensure it is fully locked in position.
Note: If you need to add water while steaming, unplug the steamer,
wait until it cools and follow the above steps. If a loud vibrating noise is
heard, then the water level is low and needs to be refilled.
USING YOUR STEAMER VERTICALLY
You can use your Steamer in the vertical position to press with steam
hanging garments and drapes.
1. Fill the water reservoir with water.
2. Hang your garment to be steamed on a clean hanger.
3. Plug the steamer into a standard electrical outlet. The red Indicator light
will flash on and off, indicating that the steamer is heating up. When
the light turns solid red, the Steamer is ready for steaming.
Warning: Care should be taken to arrange the cord so that it cannot
be pulled or tripped over. Always make sure you can move freely
without getting tangled with the cord.
Caution: Burns could occur from touching hot parts, hot water, or
steam. Use care when you turn a steam appliance upside down – there
may be hot water in the reservoir.
4. Hold your Steamer by the handle in vertical position with the head
pointing toward the fabric and then press the steam button to start
steaming.
Warning: Steam is hot. Always point steamer exit away from yourself,
other persons, pets, plants and walls. Never steam clothes while they
are being worn.
5. With your free hand, pull the fabric tight and move the Steamer over
the fabric.
6. Touch the fabric lightly with the non-stick panel, moving it in a
downward motion, beginning at the top of the garment and moving
downward. Repeat until fabric is wrinkle-free.
Tip: For more difficult wrinkles, try steaming from the underside of the
fabric.
7. When finished, press the steam button.
8. Place Steamer on a flat surface and unplug from electrical outlet.