Suncourt Entreeair Door Frame Fan User manual

OPERATION INSTRUCTIONS
FOR THE
ENTREEAIR®DOOR FRAME FAN™
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT NOTICE
INSTALLATION INSTRUCTIONS
LISTED
WARNING - To reduce the risk of fire or electric shock, DO NOT do not use this fan with a solid-state speed control device.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to
fit in a polarized outlet one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. DO NOT attempt to defeat this safety feature.
With the use of any electrical appliance, it is important to observe all basic precautions to minimize the risk associated with use, such as
electrical shock, fire or injury to persons.
Read the following instructions before using your EntreeAir®Door Frame Fan™
WARNING - To reduce the risk of fire, electric shock or injury to persons, observe the following:
1. Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
2. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the
heating equipment manufacturer's guidelines and safety standards such as those published by the National Fire Protection Agency (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and local code authorities.
3. When cutting into walls or ceilings, do not damage electrical wiring or other hidden utilities.
4. Ducted fans must always be vented outdoors.
5. The EntreeAir®Door Frame Fan can be installed on the frame of any doorway in either of the top corners. The unit must be installed on the opposite side of the doorstop
that the door shuts against to permit closing the door. Follow instructions to permanently install two screws in the door frame side (screws provided). The EntreeAir®is
installed over the screws by placing two keyhole slots over the screw heads. Make sure the unit slips down over the screws and locks into place. Multiple keyhole slots in
the EntreeAir®are provided to allow installation in either left or right corners of the doorway and to allow for choice of direction of airflow. Observe the airflow direction
arrow marked on the outside of the unit when installing. Securely attach any electrical cord to door frame with cord clips (clips provided).
CLEANING & MAINTENANCE
Before cleaning the EntreeAir®always disconnect the power cord from the outlet. Dust may be removed from the exterior surfaces using a soft cloth, the round brush attachment
of your vacuum cleaner or using a cloth that has been lightly moistened with water and a mild, non-abrasive detergent. Dust accumulation in the interior of the EntreeAir®may
be removed by using the round brush attachment of your vacuum cleaner or by attaching your vacuum cleaner hose to the blower side and blowing the dust out.
IMPORTANT WARNINGS
1.) Unplug the EntreeAir®when not in use. Turn the unit off before unplugging.
2.) DO NOT operate the EntreeAir®with a damaged plug or cord, if the unit malfunctions, becomes noisy when operating, has been dropped or otherwise damaged or if the
housing is damaged or broken. Return the unit for inspection, replacement or repair.
3.) The EntreeAir®should never be exposed to moisture. DO NOT use the unit in an open window, bathroom or laundry area where it may come into contact with water.
4.) The EntreeAir®is designed for indoor use only.
5.) Place the EntreeAir®and the electrical cord where it will not be tripped over, and is out of the traffic pattern.
6.) Never run the electrical cord under carpeting, baseboards, scatter rugs or hide it in any other way.
7.) Never insert any object or allow any object to enter the EntreeAir®through the grills, as this may damage the unit or cause it to malfunction.
8.) The motor of the EntreeAir®is equipped with a thermal fuse. Blocking rotation of the fan or airflow may cause the motor to overheat. Should the motor overheat and the
fuse open, replacement of the motor is required.
9.) DO NOT use the EntreeAir®near flammables such as as gasoline, paint or natural gas.
10.) The EntreeAir®is intended for use as described in the instructions only. Other use may cause fire, electrical shock, damage to the unit or injury to persons and will void any
warranty by the manufacturer.
11.) The EntreeAir®has a polarized plug (one blade is wider than the other). To reduce risk of shock, this plug is intended to fit into a polarized outlet only
one way. If the plug does not fit into the outlet fully, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature.
12.) If it is necessary to use an extension cord, use a heavy duty cord with adequate wire size.
13.) Pressure on the grills of the EntreeAir®may cause the fan impeller to contact these grills and damage the unit.
14.) DO NOT use strong detergents or flammable liquids to clean the EntreeAir®.
15.) The housing of your EntreeAir®is sealed at the factory. THERE ARE NO SERVICEABLE PARTS INSIDE. Attempting to open the housing will expose you to dangerous electricity,
may cause fire and will void any and all warranty.
16.) DO NOT in any way block the air grills of the EntreeAir®.

TEMPLATE
1/4”
ALLOW SCREW
TO PROJECT
THEN CHECK FOR TIGHT
FIT AND SCREW IN
FURTHER AS REQUIRED
TEMPLATE
PLACE THIS EDGE AGAINST DOOR STOP
0.9“
ONE YEAR LIMITED WARRANTY
STEP 1
Subject to the following limitations, Suncourt Inc. (manufacturer) warrants that the EntreeAir®Door Frame Fan™ will, for 1 (one) year from date of original retail purchase, but
not exceeding two years from date of manufacture, remain free from appearance of defects in workmanship or materials. This warranty is subject to the following limitations:
(a) manufacturer's liability is limited to the replacement or repair of the unit, as decided by the manufacturer; (b) a defective unit must be returned, prepaid, with proof of
purchase; and (c) this warranty does not apply to defects resulting from the alteration, abuse, accidental damage, unauthorized repair or misuse of the unit. This warranty is
given in lieu of all other warranties, guarantees and conditions on manufacturer's part, and the manufacturer shall have no tortious or other liability in respect to this
EntreeAir®Door Frame Fan™.
For service after the warranty period you may return the Suncourt EntreeAir®Door Frame Fan™ prepaid and well packaged to avoid damage in shipment, to the manufacturer
for repair.
Cut out template.
Retain instructions for future reference.
STEP 2
STEP 3
Place either narrow end of template against the top edge of
the door frame with the long edge against the doorstop.
Install one screw at each center point. Allow screws to projct
¼". Position the unit securely on the screws.
www.suncourt.com
SUNCOURT INC. • P.O. BOX 40 • DURANT, IOWA 52747-0040
1.800.999.FANS (3267)
RR1103